Effect of Cu Loading to Catalytic Selective CO Oxidation of CuO/CeO<sub>2</sub> –Co<sub>3</sub>O<sub>4</sub>
- 1 Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi, Thailand
- 2 Department of Chemical Engineering, Faculty of Engineering, Burapha University, Chonburi, Thailand
Abstract
This work studied CuO/CeO 2 -Co 3 O 4 with wt% Ce:Co ratio 95:5 for selective CO oxidation with effect of wt% Cu loading. The catalysts were prepared by co-precipitation. Characterizations of catalysts were carried out by XRD and BET techniques. The results showed a good dispersion of CuO for 5 wt% Cu loading catalysts and showed high specific surface area of catalyst. For selective CO oxidation, both 5CuO and 30CuO catalysts could remove completely CO in the presence of excess hydrogen at 423 K and 20CuO could eliminate CO completely at 443 K. Moreover, considering the selectivity to CO oxidation, the 5CuO catalyst has shown the highest selectivity of 85% while the 30CuO catalyst obtains the selectivity of 65% at the reaction temperature of 423 K.
- O. Bicakova and P. Straka, “Production of Hydrogen from Renewable Resource and its Effectiveness,” International Journal of Hydrogen Energy, Vol. 33, 2008, pp. 1335-1344.
- Z. Nada and L. Xianguo, “Transient of Carbon Monoxide Poisoning and Oxygen Bleeding in a PEM Fuel Cell Anode Catalyst Layer,” International Journal of Hydrogen Energy, Vol. 33, 2008, pp. 1335-1344.
- A. Mishra and R. Prasad, “A Review on Preferential Oxidation of Carbon Monoxide in Hydrogen Rich Gas,” Bulletin of Chemical Reaction Engineering & Catalysis, Vol. 6, No. 1, 2011, pp. 1-14.
- G. Avgouropoulos, T. Ioannides, C. Papadopoulou, J. Batista, S. Hocevar and H. K. Matralis, “A Comparative Study of Pt/γ-Al 2 O 3 , Au/α-Fe 2 O 3 and CuO–CeO 2 Catalysts for the Selective Oxidation of Carbon Monoxide in Excess Hydrogen,” Catalysis Today, Vol. 75, 2002, pp. 157-167. doi:10.1016/S0920-5861(02)00058-5
- S. Salvatore, C. Carmelo, P. M. Riccobenea, P. Giacomo and P. Alessandro, “Selective Oxidation of CO in H 2 -rich Stream over Au/CeO 2 and Cu/CeO 2 Catalysts: An Insight on the Effect of Preparationmethod and Catalyst Pretreatment,” Applied Catalysis A: General, Vol. 417- 418, 2012, pp. 66-75.
- M. Kang, M. W. song and C. H. Lee, “Catalytic Carbon Monoxide Oxidation over CoOx/CeO 2 Composite Catalysts,” Applied Catalysis A: General, Vol. 255, 2003, pp. 143-156. doi:10.1016/S0926-860X(03)00324-7
- Z. Liu, R. Zhou and X. Zheng, “Influence of Preparation Methods on CuO-CeO 2 Catalysts in the Preferential Oxidation of CO in Excess Hydrogen,” Journal of National Gas Chemistry, Vol. 17, 2008, pp. 125-129.
- J. L. Ayastuy, E. Fernandez-Puertas, M. P. Gonzalez-Marcos and M. A. Guitierrez-Ortiz, “Transition metal Promoters in CuO/CeO 2 Catalysts for CO Removal from Hydrogen-streams,” International Journal of Hydrogen Energy, Vol. 37, 2012, pp. 7385-7397. doi:10.1016/j.ijhydene.2012.02.007
- S. Christopher, H. Nair and D. Chelsey, “Study of Active Sites and Mechanism Responsible for Highly Selective CO Oxidation in H 2 Rich Atmospheres on a Mixed Cu and Ce Oxide Catalyst,” Journal of Catalysis, Vol. 266, 2009, pp. 308-319. doi:10.1016/j.jcat.2009.06.021
- M. Meng, Y. Liu, W. L. Z.Sun, L. Zhang and X. Wang, “Synthesis of Highly-dispersed CuO-CeO 2 Catalyst Through a Chemi-sorption-hydrolysis Route for CO Preferential Oxidation in H 2 -rich Stream,” International Journal of Hydrogen Energy, Vol. 37, 2012, pp. 14133-14142. doi:10.1016/j.ijhydene.2012.07.075