Efficiency of Ionic Liquid 1-Ethyl-3-Methyl-Imidazolium Acetate ([EMIM][Ac]) in Enhanced Medium Oil Recovery
- 1 Faculty of Engineering, University of Regina, Regina, Canada
- 2 Faculty of Engineering, University of Regina, Regina, Canada
- 3 Faculty of Engineering, University of Regina, Regina, Canada
Abstract
Chemical flooding is one of the most efficient methods for Enhanced Oil Recovery (EOR). This study demonstrates the efficiency of mixing different concentrations of Ionic Liquid (IL), 1-Ethyl-3-Methyl-Imidazolium Acetate ([EMIM][Ac]), with Weyburn brine to improve a medium oil recovery, Weyburn oil, from an unconsolidated sand pack sample at room conditions. Effects of Slug Size (SS), IL + brine slug initiation time, and combining IL with alkali on the Recovery Factor (RF) were investigated. This study showed that the optimum concentration of ([EMIM][AC]) was 1000 ppm and the most efficient injection time of the chemical slug was at the beginning of the flooding procedure (as secondary flooding mode). In addition, it was proved that the potential of injecting a slug of IL + brine is much better than that of introducing a slug of alkali + brine. Besides, the combination of IL and alkali (AIL) resulted in better RF than injecting either of them alone. Finally, the Surface Tension (SFT), pH, wettability alteration, and viscosity of the displacing phases were measured.
- Nilsson, S., Lohne, A. and Veggeland, K. (1997) Effect of Polymer on Surfactant Flooding of Oil Reservoirs. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 127, 241-247. https://doi.org/10.1016/S0927-7757(97)00140-4
- Speight, J.G. (2009) Enhanced Recovery Methods for Heavy Oil and Tar Sands. Gulf Publishing Company, Houston.
- Han, D., Yang, C., Zhang, Z., Lou, Z. and Chang, Y. (1999) Recent Development of Enhanced Oil Recovery in China. Journal of Petroleum Science and Engineering, 22, 181-188. https://doi.org/10.1016/S0920-4105(98)00067-9
- Nagarajan, R. and Harold, M.P. (1982) Surfactant-Polymer Interactions in Tertiary Oil Recovery. Solution Behavior of Surfactants, 2, 1391-1413. https://doi.org/10.1007/978-1-4613-3494-1_44
- Healy, R.N. and Reed, R.L. (1974) Physsicochemical Aspects of Microemulsion Flooding. Society of Petroleum Engineers Journal, 14, 491-501. https://doi.org/10.2118/4583-PA
- Jamaloei, B.Y. (2009) Insight into the Chemistry of Surfactant-Based Enhanced Oil Recovery Processes. Recent Patents on Chemical Engineering, 2, 1-10. https://doi.org/10.2174/2211334710902010001
- Lake, L.W. and Venuto, P.B. (1990) A Niche for Enhanced Oil Recovery in the 1990s. Oil & Gas Journal, 88, 62-67.
- Xiao, Y. and Malhotra, S.V. (2005) Friedel-Crafts Acylation Reactions in Pyridinium Based Ionic Liquids. Journal of Organometallic Chemistry, 690, 3609-3613. https://doi.org/10.1016/j.jorganchem.2005.04.047
- Lemos, R.C., da Silva, E.B., dos Santos, A., Guimaraes, R.C., Ferreira, B.M., Guarnieri, R.A. and Fortuny, M. (2010) Demulsification of Water-in-Crude Oil Emulsions Using Ionic Liquids and Microwave Irradiation. Energy & Fuels, 24, 4439-4444. https://doi.org/10.1021/ef100425v
- Dharaskar Swapnil, A. (2012) Ionic Liquids (A Review): The Green Solvents for Petroleum and Hydrocarbon Industries. Research Journal of Chemical Sciences, 2, 80-85.
- Hogshead, C.G., Manias, E., Williams, P., Lupinsky, A. and Painter, P. (2010) Studies of Bitumen-Silica and Oil-Silica Interactions in Ionic Liquids. Energy & Fuels, 25, 293-299. https://doi.org/10.1021/ef101404k
- Painter, P., Williams, P. and Lupinsky, A. (2010) Recovery of Bitumen from Utah Tar Sands Using Ionic Liquids. Energy & Fuels, 24, 5081-5088. https://doi.org/10.1021/ef100765u
- Williams, P., Lupinsky, A. and Painter, P. (2010) Recovery of Bitumen from Low-Grade Oil Sands Using Ionic Liquids. Energy & Fuels, 24, 2172-2173. https://doi.org/10.1021/ef901384s