Applying WIFI QoS Techniques to UMTS Networks
- 1 Department of Computer Science, Science Faculty, Abou Bekr Belkaid University, Tlemcen, Algeria
- 2
Abstract
The last decade we ha ve witnessed an unprecedented development of telecommunication technologies. This is not only due to devices capacity improvement, but also due to network performance amelioration. Moreover, new technologies were proposed such as UMTS ( 3G ), giving users more mobility and therefore more freedom. However, this resulted in a more demanding application , particularly for QoS provisioning. WIFI and UMTS are among these new telecommunication technologies. Although each one has its own QoS techniques, WIFI experiences a lack in QoS provisioning and UMTS should be further improved to guaranty QoS. Our approach is simple. To be improved, each technology can benefit from QoS techniques of the other, of course, if this is possible. In this case, it’s clear that UMTS can take advantage of WIFI QoS techniques, because UMTS uses physically a multitude of channels, using different bit rates and channel managements. While, WIFI uses a single channel with a single channel management, that is random access method. UMTS also uses a random access channel (PRACH channel), therefore we can apply WIFI QoS techniques to UMTS PRACH channel. In this study, we present WIFI and UMTS networks. We will focus on the air interface functioning of both networks to highlight similarities, then we propose two schemes inspired from WIFI QoS techniques to apply to UMTS air interface (Uu interface
- “IEEE Standard for Information Technology-Telecommunications and Information Exchange between SystemsLocal and Metropolitan Area Networks-Specific Requirements-Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications,” 1997.
- A. Based, “A Survey about IEEE 802.11e for Better QoS in WLANs,” Proceedings of the International Conference of Novel Algorithms and Techniques in Telecommunications and Networking, 2010, pp. 195-200.
- M. Ma, M. K. Denko and Y. Zhang, “Wireless Quality of Service: Techniques, Standards, and Applications,” CRC Press, Boca Raton, 2009.
- D. Fedoua, “Qualité de Service dans les réseaux locaux sans fil de type IEEE 802.11,” Ph.D. Thesis, Abou Bekr Belkaid University, Tlemcen, 2010.
- R. Shorey, A. Ananda, M. C. Chan and W. T. Ooi, “Mobile, Wireless, and Sensor Networks,” Wiley-Interscience, New York, 2006.
- A. Andreadis and G. Giambene, “Protocols for High-Efficiency Wireless Networks,” Part II, Springer, Berlin, 2002, pp. 175-204.
- C. Gessner, R. Kohn, J. Schniedenharn and A. Sitte, “UTRA TDD Protocol Operation,” Proceedings of The 11th IEEE International Symposium on Personal, Indoor and Mobile Radio Communications, Vol. 2, London, 2000, pp. 1226-1230.
- 3GPP, “Radio Interface Protocol Architecture,” 2002.
- 3GPP, “Physical Layer—General Description. 1999. http://www.3gpp.org/ftp/specs/archive/25_series/25.201/
- Y. Yang and T. S. P. Yum, “Analysis of Power Ramping Schemes for UTRA-FDD Random Access Channel,” Proceedings of IEEE Global Telecommunications Conference, Vol. 5, Beijing, 2004, pp. 3305-3309.
- W.-H. Sheen, C.-C. Tseng and J.-S. Ho, “Burst Synchronization of Slotted Random Access With Preamble Power Ramping in the Reverse Link of CDMA Systems,” IEEE Transactions on Wireless Communications Conference, Vol. 2, No. 5, 2003, pp. 953-963. doi:10.1109/9.402235
- I. Forkel, B. Wegmann and E. Schulz, “On the Capacity of a UTRA-TDD Network with Multiple Services,” Proceedings of ICC 2002 IEEE International Conference, Vol. 1, 2002, pp. 585-589.
- C. Mihailescu, X. Lagrange and P. Godlewski, “Performance Evaluation of a Dynamic Resource Allocation Algorithm for UMTS-TDD Systems,” Proceedings of Vehicular Technology Conference, Vol. 3, Tokyo, 2000, pp. 2339-2343.
- 3GPP, “Physical layer procedures (FDD) (Release 10),” 2011.