Research ArticleOpen AccessGoogle Scholar indexed
EMTP Induction Motor Model from Modal Measurements for Inverter Surge Analysis
Department of Electrical and Electronics Engineering, Doshisha University, Kyoto, Japan
Department of Electrical and Electronics Engineering, Doshisha University, Kyoto, Japan
- 1 Department of Electrical and Electronics Engineering, Doshisha University, Kyoto, Japan
- 2 Department of Electrical and Electronics Engineering, Doshisha University, Kyoto, Japan
Circuits and Systems·Volume 04 (2013)·Pages 16–19·Published 22 January 2013·DOI10.4236/cs.2013.41004
Copy link · social · email
Abstract
The over-voltage phenomenon is usually described using the traveling wave and reflection phenomena in variable speed drive system. A voltage pulse, initiated at the inverter, being reflected at the motor terminals due to a mismatch between the surge impedance of the motor and the cable. In this paper, resistance, inductance and capacitance of the cable and the motor windings are obtained experimentally by modal measurements and suitable models are developed to match the experimental results by considering resonance in the motor winding. This paper emphasize on Induction motor model using the theory of natural modes of propagation. The developed model validity is investigated for inverter surge application.
KeywordsInduction MotorModal MeasurementsInverter SurgeEMTP
- H. Paula, M. L. R. Chaves, D. A. Andrade, J. L. Domingos and M. A. A. Freitas, “A New Strategy for Differential over Voltages and Common Mode Currents Determination in PWM Induction Motor Drives,” IEEE International Conference on Electric Machines and Drives, San Antonio, 15 May 2005, pp. 1075-1081,
- L. A. Saunders, G. L. Skibinski, S. T. Evon and D. L. Kempkes, “Riding the Reflected Wave—IGBT Drive Technology Demands New Motor and Cable Considerations,” IEEE 43rd IAS Annual Meeting, Philadelphia, 23-25 September 1996, pp.75-84.
- F. Moreira, T. A. Lipo, G. Venkataramanan and S. Bernet, “High Frequency Modeling for Cable and Induction Motor Overvoltage Studies in Long Cable Drives,” IEEE Transactions on Industry Applications, Vol. 38, No. 5, 2002, pp. 1297-1306. doi:10.1109/TIA.2002.802920
- J. C. Oliveira, R. J. Paulsen, M. A. Amaral and D. Andrade, “Electrical Transmission System with Variable Frequency through Long Length Cable,” Offshore Technology Conference, Houston, 6-9 May 1996. doi:10.4043/8058-MS
- T. Makato, W. Kotaro, O. Hisashi, M. Hirataka and N. Nagaoka, “Analysis of Propagation of the Inverter Voltage and Electric Cable Surge,” Institute of Electrical Engineers Japan Transaction on Power and Energy, Vol. 126, No. 6, 2006, pp.771-777.
- W. Scott-Mayer, “EMTP Rule Book,” Bonneville Power Administration, Portland, 1984.
- L. M. Wedepohl, “Application of Matrix Methods to the Solution of Travelling-Wave Phenomena in Polyphase Systems,” Proceedings of the Institution of Electrical Engineers, Vol. 110, No. 12, 1963, pp. 2200-2212.
- A. Ametani, “A General Formulation of Impedance and Admittance,” IEEE Transactions on Power Apparatus and Systems, Vol. 99, No. 3, 1980, pp. 902-908.
- A. Semlyen and A. Dabuleanu, “Fast and Accurate Switching Transients Calculations on Transmission Line with Ground Return Using Recursive Convolution,” IEEE Transactions on Power Apparatus and Systems, Vol. 94, No. 2, 1975, pp. 561-571.