Design of Low Voltage, Low Power (IF) Amplifier Based-On MOSFET Darlington Configuration
- 1 Electrical Department, College of Engineering, Babylon University, Babylon, Iraq
Abstract
This paper presents a different approach of Intermediate Frequency (IF) amplifier using 0.18 μm MIETEC technology channel length of MOSFET Darlington transistors. In contrast to Bipolar conventional Darlingtonpair, a MOSFET Darlington configuration is employed to reduce supply voltage (V DD ) and DC consumption power (P c ). The frequency response parameters of the proposed design such as bandwidth, gain bandwidth product, input/output noises and noise figure (NF) are improved in proposed (IF) amplifier. Moreover, a dual-input and dual-output (DIDO) IF amplifier constructed from two symmetrical single input and single output (SISO) (IF) amplifier is proposed too. The idea is to achieve improved bandwidth, and flat response, because these parameters are very important in high frequency applications. Simulation results that obtained by P-SPICE program are 1.2 GHz Bandwidth (BW), 3.4 GHz (gain bandwidth product), 0.5 mW DC consumption power (P c ) and the low total output noise is 12 nV with 1.2 V single supply voltage.
- El-S. A. M. Hasaneen and N. Okely, “On-Chip Inductor Technique for Improving LNA Performance Operating at 15 GHz,” Circuits and Systems, Vol. 3, No. 4, 2012, pp. 334-341. doi:10.4236/cs.2012.34047
- P. Kakoty, “Design of a High Frequency Low Voltage CMOS Operational Amplifier,” International Journal of VLSI Design & Communication Systems (VLSICS), Vol. 2, No. 1, 2011, pp. 73-85. doi:10.5121/vlsic.2011.2107
- A. Motayed and S. N. Mohammad, “Tuned Performance of Small-Signal BJT Darlington Pair,” Solid-State Electronics, Vol. 45, 2001, pp. 369-371. doi:10.1016/S0038-1101(00)00247-1
- C. Arnott, “Wideband Gain Block Amplifier Design Techniques,” Applied Microwave & Wireless, 2001, pp. 98109. http://data.eefocus.com/myspace/0/2029/bbs/1192675584/23b66dea.pdf
- S. N. Shukla and S. Srivastava, “Small-Signal Amplifier with Three Dissimilar Active Devices in Triple Darlington Topology,” International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, Vol. 1, No. 6, 2012, pp. 502-508.
- C.-S. Lin, M.-D. Tsai, H. Wang, Y.-C. Wang and C.-H. Chen, “A Monolithic HBT Broadband Amplifier Using Modified Triple Darlington Configuration,” 12th GAAS Symposium, Amsterdam, 2004, pp.331-334.
- H. Cebi, “A High Linearity Darlington Intermediate Frequency (IF) Amplifier for Wide Bandwidth Applications,” Microwave Journal, Vol. 53, No. 11, 2011, pp. 18-24.
- A. M. H. Sayed ElAhl, M. M. E. Fahmi and S. N. Mohammad, “Quantitative Analysis of High Frequency Performance of Modified Darlington Pair,” Solid-State Electronics, Vol. 46, No. 4, 2002, pp. 593-595. doi:10.1016/S0038-1101(01)00308-2
- R. L. Boylestad, L. Nashelsky and F. J. Monssen, “Electronic Devices and Circuit Theory,” 8th Edition, Prentice Hall, Upper Saddle River, 2002.
- S.-H. Kim, Z.-J. Jin, Y.-B. Chae and T.-Y. Yun, “Small Internal Antenna Using Multiband, Wideband, and HighIsolation MIMO Techniques,” ETRI Journal, Vol. 35, No. 1, 2013, pp. 51-57. doi:10.4218/etrij.13.0112.0183