This paper presents an electronically tunable current/trans-impedance-mode biquad universal filter employing only single multi-output current controlled current conveyor trans-conductance amplifier (MO-CCCCTA) and two grounded capacitors. The proposed filter realizes all the standard filter func-tions i.e. low pass (LP), band pass (BP) and high pass (HP), notch and all pass (AP) filters in the current form at high impedance output through appropriate selection of the input signals, without any matching conditions. Simultaneously, it can also realize all the standard filter functions in trans-impedance form from the same circuit topology. The circuit does not require inverting-type input current signal(s) and double input current signal(s) to realize all the responses in the design. The validity of proposed filter is verified through PSPICE simulations.
S. Minaei and S. Türk?z, “New Current-Mode Cur-rent-Controlled Universal Filter with Single Input and Three Outputs,” International Journal of Electronics, Vol. 88, No. 3, 2001, pp. 333-337. doi:10.1080/00207210010013201
T. Katoh, T. Tsukutani, Y. Sumi and Y. Fukui, “Electronically Tunable Current-Mode Universal Filter Employing CCCIIs and Grounded Capacitors,” International Symposium on Intelligent Signal Processing and Communications, 2006, pp. 107-110.
S. Minaei and S. Türk?z, “Current-Mode Elec-tronically Tunable Universal Filter Using Only Plus-Type Cur-rent Controlled Conveyors and Grounded Capacitors,” Elec-tronics and Telecommunication Research Institute Journal, Vol. 26, No. 4, 2004, pp. 292-296. doi:10.4218/etrij.04.0103.0146
I. A. Khan and M. H. Zaidi, “Multifunc-tion Translinear-C Current Mode Filter,” International Journal of Electronics, Vol. 87, No. 6, 2000, pp. 1047-1051. doi:10.1080/002072100412984
M. Soliman, “Current Mode Universal Filters Using Current Conveyors,” Circuits Systems and Signal Processing, Vol. 27, No. 3, 2008, pp. 405-427. doi:10.1007/s00034-008-9034-y
T. Tsukutani, Y. Sumi, S. Iwanari and Y. Fukui, “Novel Current-Mode Bi-quad Using MO-CCCIIs and Grounded Capacitors,” Proceed-ings of 2005 International Symposium on Intelligent Signal Processing and Communication Systems, 13-16 December 2005, pp. 433-436.
D. R. Bhaskar, A. K. Singh, A. K. Sharma and R. Senani, “New OTA-C Universal Cur-rent-Mode/Trans-Admi- ttance Biquads,” Institute of Electronics, Information and Communication Engineering Electronics Express, Vol. 2, No. 1, 2005, pp. 8-13. doi:10.1587/elex.2.8
J. Wu and E. I. El-Masry, “Universal Voltage and Current-Mode OTAs Based Biquads,” Interna-tional Journal of Electronics, Vol. 85, No. 5, 1998, pp. 553-560. doi: 10.1080/002072198134355
C. M. Chang and M. J. Lee, “Voltage-Mode Multifunction Filter with Single Input and Three Outputs Using Two Compound Current Conveyors,” IEEE Transactions on Circuits and Systems- I: Fundamental Theory and Applications, Vol. 46, No. 11, 1999, pp. 1364-1365. doi:10.1109/81.802827
S. Maheshwari, “Analogue Signal Processing Applications Using a New Circuit Topology,” IET Circuits, Devices and Systems, Vol. 3, No. 3, 2009, pp. 106-115. doi: 10.1049/iet-cds.2008.0294
T. Praveen, M. T. Ahmed and I. A. Khan, “A Canonical Voltage-Mode Universal CCCII-C Filter,” Journal of Active and Passive Devices, Vol. 4, No. 1-2, 2009, pp. 7-12.
S. Maheshwari, “High Perfor-mance Voltage-Mode Multifunction Filter with Minimum Component Count,” WSEAS Transactions on Electronics, Vol. 5, No. 6, 2008, pp. 244-249.
M. T. Abuelma’atti and N. A. Tassaduq, “A Novel Three Inputs and One Output Universal Current-Mode Filter Using Plus-Type CCIIs,” Microelectronics Journal, Vol. 30, No. 3, 1999, pp. 287-292. doi:10.1016/S0026-2692(98)00169-4
R. Senani, “New Universal Current Mode Biquad Employing All Grounded Passive Components but Only Two DOCCs,” Journal of Active and Passive Devices, Vol. 1, No. 3-4, 2006, pp. 281-288.
M. T. Abuelma’atti and M. L. Al-qahtani, “Universal Current-Contolled Current-Mode Filter with Three Inputs and One Output Using Current Controlled Conveyor,” Active Passive Electronics Components, Vol. 21, No. 1, 1998, pp. 33-41. doi:10.1155/1998/83413
W. Tangsriart and W. Surakampontorm, “Electronically Tunable Current-Mode Uni-versal Filter Employing Only Plus-Type Current-Controlled Conveyors and Grounded Capacitors,” Circuits Systems and Signal Processing, Vol. 25, No. 6, 2006, pp. 701-713. doi:10.1007/s00034-005-0908-y
W. Tangsrirat and W. Surakampontorm, “Low-Component Current-Mode Universal Filter Using Current-Controlled Conveyors and Grounded Ca-pacitors,” Journal of Active and Passive Devices, Vol. 4, No. 3, 2009, pp. 259-264.
C. M. Chang, “Universal Active Current Filter Using Single Second-Generation Current Con-trolled Conveyor,” International Journal of Circuits, Systems and Signal Processing, Vol. 1, No. 1, 2007, pp. 194-198.
M. Siripruchyanun and W. Jaikla, “Current Controlled Current Conveyor Transconductance Amplifier (CCCCTA): A Building Block for Analog Signal Processing,” Electrical Engineering, Vol. 90, No. 6, 2008, pp. 443-453. doi:10.1007/s00202-007-0095-x
M. Siripruchyanun and W. Jaikla, “Electronically Controllable Current-Mode Universal Biquad Filter Using Single DO-CCCDTA,” Circuits System Signal Processing, Vol. 27, No. 1, 2008, pp. 113-122. doi:10.1007/s00034-008-9014-2
W. Tangsriart, “Cur-rent-Tunable Current-Mode Multifunction Filter Based on Dual-Output Current-Controlled Conveyors,” International Journal of Electronics and Communications, Vol. 61, No. 8, 2007, pp. 528-533. doi:10.1016/j.aeue.2006.09.005
T. Tsukutani, Y. Sumi and N. Yabuki, “Versatile Current Mode Biquadratic Circuit Using Only Plus Type CCCIIs and Grounded Capacitors,” International Journal of Electronics, Vol. 94, No. 12, 2007, pp.1147-1156. doi:10.1080/00207210701789998
Y. Wang and R. Raut, “A Design of Transresistance Amplifier for High Gain-Bandwidth Applications,” Proceedings of the 2003 10th IEEE International Conference on Electronics, Circuits and Systems, 14-17 December 2003, pp. 185-188.
A. Carlosena and E. Cabral, “Novel Transimpedance Filter Topology for Instrumentation,” IEEE Transactions on Instrumentation and Measurement, Vol. 46, No. 4, 1997, pp. 862-867. doi:10.1109/19.650789
M. Soliman, “Mixed-Mode Biquad Circuits,” Microelectronics Journal, Vol. 27, No. 6, 1996, pp. 591-594. doi:10.1016/0026-2692(95)00121-2
J. Ramirez-Angulo, M. Ro-binson and E. Sanchez-Sinencio, “Current-Mode Conti-nuous-Time Filters: Two Design Approaches,” IEEE Trans-actions on Circuits and Systems-II: Analog and Digital Signal Processing, Vol. 39, No. 6, 1992, pp. 337-341. doi:10.1109/82.145290
S. Minaei, G. Topcu and O. Ci-cekoglu, “Low Input Impedance Trans-Impedance Type Mul-tifunction Filter Using Only Active Elements,” International Journal of Electronics, Vol. 92, No. 7, 2005, pp. 385-392. doi:10.1080/00207210412331334789
A. Fabre, O. Saiid and H. Barthelemy, “On the Frequency Limitations of the Cir-cuits Based on Second Generation Current Conveyors,” Analog Integrated Circuits and Signal Processing, Vol. 7, No. 2, 1995, pp. 113-129. doi:10.1007/BF01239166
M. Siripruchya-nun, P. Silapan and W. Jaikla, “Realization of CMOS Current Controlled Current Conveyor Transconductance Amplifier and Its Application,” Journal of Active and Passive Devices, Vol. 4, No. 1-2, 2009, pp. 35-53.
E. Yuce, S. Tokar, A. Kizilkaya and O. Cicekoglu, “CCII-Based PID Controllers Employing Grounded Passive Componensts,” International Journal of Electronics and Communications, Vol. 60, No. 5, 2006, pp. 399-403. doi:10.1016/j.aeue.2005.03.017