A New Voltage-Mode Universal Biquadratic Filter Using Single UVC
- 1 Department of Electronics and Communication Engineering, Maharaja Agrasen Institute of Technology, Rohini, New Delhi, India
- 2 Electronics and Communication Engineering Cell, Radiance EdutechTM, DDA Market, Paschim Vihar, Delhi, India
- 3 Department of Electronics and Communication Engineering, Al-Falah University, Faridabad, India
Abstract
The paper presents a new universal biquadratic filter using single universal voltage conveyor (UVC), two resistors and two capacitors. The offered structure has three inputs and one output and can realise all the five basic biquadratic filters: high-pass (HP), low-pass (LP), band-reject (BR), band-pass (BP) and all-pass (AP) from the same circuit topology. The proposed universal filter also provides following advantageous features, not available simultaneously in any UVC based universal biquadratic filter so far: (i) low active and passive sensitivities, (ii) independent control of natural frequency (ω 0 ) and bandwidth (BW) and (iii) no requirement of any component matching condition and inversion of input signal(s) (as needed in most of the earlier reported structures). The workability of proposed structure has been presented by SPICE (Version 16.5) simulation using 0.18 μm TSMC technology.
- Pushkar, K.L., Bhaskar, D.R. and Prasad, D. (2013) Voltage-Mode New Universal Biquad Filter Configuration Using a Single VDIBA. Circuits, Systems, Signal, and Processing, 33, 275-285.
- Prasad, D., Bhaskar, D.R. and Singh, A.K. (2009) Multi-Function Biquad Using Single Current Differencing Transconductance Amplifier. Analog Integrated Circuits and Signal Processing, 61, 309-313. https://doi.org/10.1007/s10470-009-9310-1
- Keskin, A.U. (2006) Multi-Function Biquad Using Single CDBA. Electrical Engineering, 88, 353-356. https://doi.org/10.1007/s00202-004-0289-4
- Bashir, S.A. and Shah, N.A. (2012) Voltage Mode Universal Filter Using Current Differencing Buffered Amplifier as an Active Device. Circuits and Systems, 3, 1-4. https://doi.org/10.4236/cs.2012.33038
- Herencsar, N., Koton, J., Vrba, K. and Cicekoglu, O. (2009) Single UCC-N1B 0520 Device as a Modified CFOA and Its Application to Voltage- and Current-Mode Universal Filters. Applied Electronics, Pilsen, 9,127-130.
- Shah, N.A., Rather, M.F. and Iqbal, S.Z. (2005) A Novel Voltage-Mode Universal Filter Using a Single CFA. Active and Passive Electronic Devices, 1, 183-188.
- Horng, J.W., Chang, C.K. and Chu, J.M. (2002) Voltage-Mode Universal Biquadratic Filter Using Single Current-Feedback Amplifier. IEICE Transactions on Fundamentals, 85, 1970-1973.
- Herencsar, N., Koton, J. and Vrba, K. (2011) KHN-Equivalent Voltage-Mode Filters Using Universal Voltage Conveyors. AEU - International Journal of Electronics and Communications, 65, 154-160. https://doi.org/10.1016/j.aeue.2010.02.005
- Minarcik, M. and Vrba, K. (2007) Continuous-Time Multifunctional Filters with Wide Bandwidth Using Universal Voltage Conveyors. Proceedings of the Sixth International Conference on Networking. https://doi.org/10.1109/ICN.2007.32
- Pushkar, K.L. and Gupta, K. (2017) MISO-Type Voltage-Mode Universal Biquadratic Filter Using Single Universal Voltage Conveyor. Circuits and Systems, 8, 227-236. https://doi.org/10.4236/cs.2017.89015
- Minarcik, M. and Vrba, K. (2006) Low-Output and High-Input Impedance Frequency Filters Using Universal Voltage Conveyor for High-Speed Data Communication Systems. In Proceedings of international conference on networking ICN 2006, Mauritius, 155-158.
- Herencsar, N., Koton, J. and Vrba, K. (2009) A New Electronically Tunable Voltage-Mode Active-C Phase Shifter Using UVC and OTA. IEICE Electronics Express, 6, 1212-1218. https://doi.org/10.1587/elex.6.1212