Research ArticleOpen AccessGoogle Scholar indexed
Research of the Issue of Lightening the Construction of the Gin Saw Cylinder
Namangan Engineering and Technological Institute, Namangan, Uzbekistan
Namangan Engineering and Technological Institute, Namangan, Uzbekistan
Namangan Engineering and Technological Institute, Namangan, Uzbekistan
- 1 Namangan Engineering and Technological Institute, Namangan, Uzbekistan
- 2 Namangan Engineering and Technological Institute, Namangan, Uzbekistan
- 3 Namangan Engineering and Technological Institute, Namangan, Uzbekistan
Copy link · social · email
Abstract
The article investigates the problem of lightening the construction of the saw cylinder of the gin by drilling a central longitudinal through hole on the shaft and cutting circular holes on the saw blades. This is accompanied by a relatively large decrease in the mass of the saw cylinder and a relatively smaller decrease in the axial moment of inertia of the cross-sectional area of the shaft, which provides the maximum deflection of the saw cylinder under the action of its own gravity in the middle of the span is from 0.450 mm to 0.406 mm.
KeywordsGinMovable ObjectSaw CylinderShaftSaw BladeAxial Moment of InertiaCross-SectionDeflectionCircular Hole
- Jabborov, G., et al. (1987) Technology of Primary Processing of Seed Cotton. 328 p.
- Yunusov, S., Djuraev, A. and Mirzaumidov, A. (2018) Analysis of slitovnogo pilnogo vala na prochnost v staticheskom sostoyanii. Journal of Fergana Polytechnic Institute, 2, 40-45.
- Djuraev, A. and Khudoikulov, Sh. (2019) Analysis of the Results of Structural Development Tests with a Support That Reduces the Bending of the Cylindrical Shaft Bearings. NamMTI Scientific and Technical Journal, No. 2, 119-123.