Modeling and Investigation of the Wall Thickness Changes and Process Time in Thermo-Mechanical Tube Spinning Process Using Design of Experiments
- 1
- 2
- 3
Abstract
Tube spinning technology is one of the effective methods of manufacturing large diameter thin-walled shapes. In this research, effects of major parameters of thermo mechanical tube spinning process such as preform's thickness, percentage of thickness reduction, mandrel rotational speed, feed rate, solution treatment time and aging treatment time on the wall thickness changes and process time in thermo-mechanical tube spinning process for fabrication of 2024 aluminum spun tubes using design of experiments (DOE), are studied. The statistical results are verified through some experiments. Results of experimental evaluation are analyzed by variance analysis and mathematic models are obtained. Finally using these models, input parameters for optimum production are achieved.
- S. Kobayashi and E. G. Thomson, “Theory of spin forging,” China Institute for Radiation Protection Annalen, Vol. 10, pp. 114-123, 1961-1962.
- H. Hasimoto, S. Kita, T. Shibasaka and S. Yoshida, “On the deformation in tube spinning,” Himegi Industrial University Report, No. 33A, 1980.
- K. M. Rajan and K. Narasimhan, “Effect of heat treatment of prefom on the mechanical properties of flow formed AISI 4130 Steel Tubes—a theoretical and experimental assessment,” Journal of Materials Processing Technology, Vol. 125-126, pp. 503-511, 2002.
- Y. Xu and S. H. Zhang, “3D rigid-plastic FEM numerical on tube spinning,” Journal of Materials Processing Technology, Vol. 113, pp. 710-713, 2001.
- S. C. Chang and C. C. Wang, “Fabrication of 2024 aluminum spun tube using a thermo mechanical treatment process,” Journal of Materials Processing Technology, Vol. 108, pp. 294-299, 2001.
- American Society for Metals Handbook, Vol. 4: Heat Treating, American Society for Metals International, 2nd edition, 1994.
- D. C. MontGomery, “Design of experimentals & statistica modeling,” McGrow Hill Incorporation, New York, 2005.
- Z. E. Ma, “Optimal angle of attack in tube spinning,” Journal of Materials Processing Technology, Vol. 37, pp. 217-224, 1993.