CFD Analysis of Single and Multiphase Flow Characteristics in Elbow
- 1 Mechanical Engineering, University of Michigan-Flint, Flint, USA
Abstract
Computational fluid dynamics (CFD) analysis of single- phase and two-phase flow was performed in a 90 degree horizontal to vertical elbow with 12.7 mm inside diameter. Characteristic flow behavior was investigated at six different upstream and downstream locations of the elbow. To evaluate the effects of different phases, three different air veloci-ties and three different water velocities were used during this study. Commercial CFD code FLUENT was used to perform analysis of both single and multiphase flows. Pressure and velocity profiles at six locations showed an increase in pressure at the elbow geometry with decreasing pressure as fluid leaves from the elbow. Pressure drop behavior observed to be similar for single-phase and multiphase flows. Comparison of CFD results with available empirical models showed reasonably good agreement.
- N. M. Crawford, G. Cunningham and P. L. Spedding, “Predic-tion of Pressure Drop for Turbulent Fluid Flow in 90? Bends,” Proceedings of the Institution of Mechanical Engineers, Vol. 217, No. 3, 2003, pp. 153-155. doi:10.1243/095440803322328827
- P. L. Spedding, E. Benard and G. M. McNally, “Fluid Flow through 90? Bends,” Developments in Chemical Engineering and Mineral Process-ing, Vol. 12, No. 1-2, 2004, pp. 107-128. doi:10.1002/apj.5500120109
- A. Azzi and L. Friedel, “Two-Phase upward Flow 90? Bend Pressure Loss Model,” Forschung im Ingenieurwe- sen, Vol. 69, No. 2, 2005, pp. 120-130. doi:10.1007/s10010-004-0147-6
- J. M. Chenoweth and M. W. Martin, “Turbulent Two- Phase Flow,” Petroleum Refiner, Vol. 34, No. 10, 1955, pp. 151-155.
- R. W. Lockhart and R. C. Martinelli, “Proposed Correlation of Data for Isothermal Two-Phase Two-Component Flow in Pipes,” Chemical Engi-neering Progress, Vol. 45, No. 1, 1949, pp. 39-48
- D. Chisholm, “Two-Phase Flow in Pipe Lines and Heat Exchang-ers,” Journal of Heat Transfer, Vol. 129, 1983, pp. 101-107.
- S. Benbella, M. Al-Shannag and Z. A. Al-Anber, “Gas- Liquid Pressure Drop in Vertical Internally Wavy 90 Degree Bend,” Experimental Thermal and Fluid Science, Vol. 33, No. 2, 2009, pp. 340-347. doi:10.1016/j.expthermflusci.2008.10.004
- G. R. Rippel, C. M. Eidt Jr. and H. B. Jordan, “Two Phase Flow in a Coiled Tube, Pressure Drop, Holdup, and Liquid Phase Axial Mixing,” Industry & Engineering Chemistry Process Design and Devel-opment, Vol. 5, No. 1, 1966, pp. 32-39. doi:10.1021/i260017a007
- L. B. Ellis and P. N. Joubert, “Turbulent Shear Flow in a Curved Duct,” Journal of Fluid Mechanics, Vol. 62, No. 1, 1974, pp. 65-84. doi:10.1017/S0022112074000589
- I. A. Hunt and P. N. Joubert, “Effects of Small Streamline Curvature on Turbulent Duct Flow,” Journal of Fluid Mechanics, Vol. 91, No. 4, 1979, pp. 633-659. doi:10.1017/S0022112079000380
- J. A. C. Humphrey, J. H. Whitelaw and G. Yee, “Turbulent Flow in a Square Duct with Strong Curvature,” Journal of Fluid Mechanics, Vol. 103, 1981, pp. 443-446. doi:10.1017/S0022112081001419
- W. R. Briley, R. C. Buggeln and H. McDonald, “Computational of Laminar and Turbulent Flow in 90? Square- Duct and Pipe Bends Using the Navier-Stokes Equations,” DTIC Report No. R82-920009-F, 1982.
- I. Fluent, “Fluent 6.3 User Guide,” Fluent Inc., Lebanon, 2002.