Numerical Study of a Confined Axisymmetric Jet Impingement Heat Transfer with Nanofluids
- 1 Department of Mechanical Engineering, National Cheng-Kung University, Tainan
- 2 Department of Mechanical Engineering, National Cheng-Kung University, Tainan
Abstract
A numerical simulation on confined impinging circular jet working with a mixture of water and Al2O3 nanoparticles is investigated. The flow is turbulent and a constant heat flux is applied on the heated plate. A two-phase mixture model approach has been adopted. Different nozzle-to-plate distance, nanoparticle volume concentrations and Reynolds number have been considered to study the thermal performances of the system in terms of local, average and stagnation point Nusselt number. The local Nusselt number profiles show that the highest values within the stagnation point region, and the lowest at the end of the heated plate. It is observed that the average Nusselt number increases for increasing nanoparticle concentrations, moreover, the highest values are observed for H/D=5, and a maximum increase of 10% is obtained at a concentration equal to 5%.
- I. Gherasim, G. Roy, C.T. Nguyen, D. Vo-Ngoc, "Heat transfer enhancement and pumping power in confined radial flows using nanoparticle suspensions (nanofluids), " International Journal of Thermal Sciences Vol. 50, 2011,pp. 369-377.
- Y. T. Yang, F. H. Lai, "Numer-ical study of heat transfer enhancement with the use of nanofluids in radial flow cooling system," International Journal of Heat and Mass Transfer, Vol. 53, 2010, pp.5895-5904.
- Y. T. Yang, F. H. Lai, "Numerical investigation of cooling performance with the use of Al2O3/water nanofluids in a radial flow system," Interna-tional Journal of Thermal Sciences, Vol. 50, 2011, pp. 61-72.
- O. Manca, P. Mesolella, S. Nardini, D. Ricci, "Numerical study of a confined slot impinging jet with nanofluids," Nanoscale Research Letters, 6:188, 2011, pp. 1-16.
- I. Gherasim, G. Roy, C.T. Nguyen, D. Vo-Ngoc, "Experimenal investigation of nanofluids in confined laminar radial flows," International Journal of Thermal Sciences, Vol. 48, 2009,pp. 1486-1493.
- G. Roy, C.T. Nguyen, P. R. Lajoie, "Numerical investigation of laminar flow and heat transfer in a radial flow cooling system with the use of nanofluids," Superlattices and Microstructures, Vol. 35, 2004, pp. 497-511.
- G. Roy, I. Gherasim, F. Nadeau, G. Poitras, C. T. Nguyen, “Heat transfer performance and hydrodynamic behavior of turbulent nanofluid radial flows,” International Journal of Thermal Sciences, Vol. 58, 2012,pp. 120-129.
- F. Menter, Two-equation eddy-viscosity turbulence models for engineering appli-cations, AIAA J., 32 (8), 1994, pp. 1598-1605.
- S.E.B. Maiga, N. Cong Tam, N. Gala-nis, G. Roy, T. Mare, M. Coqueux, “Heat transfer en-hancement in turbulent tube flow using Al2O3 nanopar-ticle suspension,” International Journal of Numerical Methods Heat Fluid Flow, Vol. 16, 2006, pp. 275-292.
- S.J. Palm, G. Roy, C.T. Nguyen, “Heat transfer enhancement with the use of nanofluids in radial flow cooling systems considering temperature dependent properties,” Applied Thermal Engineering, Vol. 26, 2006, pp. 2209-2218.
- M. Manninen, V. Taivassalo, S. Kallio, On the Mixture Model for Multiphase Flow, VTT Publications 288, Technical Research Centre of Finland, 1996.