Embedded Control of LCL Resonant Converter Analysis, Design, Simulation and Experimental Results
- 1
- 2
Abstract
The Objective of this paper is to give more insight into CCM Operation of the LCL Converter to obtain op-timum design using state-space analysis and to verify the results using PSPICE Simulation for wide variation in loading conditions. LCL Resonant Full Bridge Converter (RFB) is a new, high performance DC-DC con-verter. High frequency dc-dc resonant converters are widely used in many space and radar power supplies owing to their small size and lightweight. The limitations of two element resonant topologies can be over-come by adding a third reactive element termed as modified series resonant converter (SRC). A three ele-ment resonant converter capable of driving voltage type load with load independent operation is presented. We have used embedded based triggering circuit and the embedded ‘C’ Program is checked in Keil Software and also triggering circuit is simulated in PSPICE Software. To compare the simulated results with hardware results and designed resonant converter is 200W and the switching frequency is 50 KHz.
- A. K. S. Bhat, “Analysis and design of a modified series resonant converter,” IEEE Transactions, Power Electronics, Vol. 8, pp. 423-430, October 1995.
- A. K. S. Bha, “Analysis and design of LCL-Type series resonant converter,” IEEE INTELEC, pp. 172-178, 1994.
- A. K. S. Bhat, “Analysis and design of a fixed-frequency LCL-Type series resonant converter with capacitive output filter,” IEE PROC-Circuits Devices System, Vol. 144, No. 2, April 1997.
- R. Sevverns, “Topologie for three element resonant converter,” in IEEE Applied Power Electronics, Conference Record, pp. 712-722, March 1990.
- E. G. Schmidtner, “A new High-Frequency resonant Converter topology,” in High Frequency Power Conversion Conference Record, pp. 390-403, 1988.
- R. L. Steigerwald, “A comparison of half bridge resonant converter topology,” IEEE Transaction, Power Electronics, Vol. 3, pp.174-182, April 1988.
- T. H. Solane, “Design of high-efficiency series resonant converter above resonance,” IEEE Transactions, Aerospace Electronics System, Vol. 26, pp. 393-402, March 1990.
- V. Agarwal, V. Belaguli, and A. K. S. Bhat, “Large signal analysis using discrete time domain modeling for LCC-type parallel resonant converter operating in discontinuous current mode,” in Canadian Conference Electrical and Computer Engineering, pp. 83–88, 1993.
- K. S Bhat, “Analysis and design of a series parallel resonant converter,” IEEE Transactions on Power Electronics, Vol. 8, pp.1–11, 1993.
- V. Belaguli, “Series-parallel and parallel series resonant converters operating on the utility line-analysis, simulation and experimental results,” Ph.D. Dissertation, University Victoria, 1995.
- R. Severns, “Topologies for three element resonant converters,” in IEEE Applied Power Electronics, Conference Record, pp. 712–722, 1990.
- H. Neufeld, “Half-bridge resonant converter using the CS-360,” Cherry Semiconductor, Application Note, 1990.
- B. P. McGrath, “Design of a soft-switched 6-kw battery charger for traction applications,” IEEE Transactions on Power Electronics, Vol. 22, No. 4, pp.1136–1142, July 2007.
- H. Deng, “Analysis and design of iterative learning control strategies for UPS inverters,” IEEE Transactions on Industrial Electronics, Vol. 54, No. 3, pp. 1739–1751, June 2007.