Study and Optimization of a Photovoltaic Mill System Functioning on the Course of the Sun
- 1 Department of Physics, UFR Applied Sciences and Information and Communication Technologies, Alioune Diop University of Bambey, Bambey, Senegal
- 2 Department of Physics, UFR Applied Sciences and Information and Communication Technologies, Alioune Diop University of Bambey, Bambey, Senegal
- 3 Department of Physics, UFR Applied Sciences and Information and Communication Technologies, Alioune Diop University of Bambey, Bambey, Senegal
- 4 Universitary Institute of Technology, University of Thies, Thies, Senegal
- 5 Department of Physics, Faculty of Science and Technology, Cheikh Anta Diop University of Dakar, Dakar, Senegal
Abstract
This paper dealt with the optimization of the performance of a photovoltaic mill system operating on the sun race. Depending on the characteristics of the powered load which is a DC motor driving a grain mill and on the weather conditions (temperature and illumination), we noted a very big difference between the potential maximum power and that actually transferred to the load. In order to improve the overall efficiency of the system, we use an adaptation circuit consisting of a boost converter controlled by a numerical MPPT (Maximum Power Point Tracking) command. With the Perturb & Observe (P & O) algorithm, the MPPT control measure the photocurrent, the photo tension and the power released by the photovoltaic generator. From this result, the MPPT control adjusts the duty cyclic of the converter to bring the system to the optimum operating point. Hence, using MATLAB/Simulink software, we did the modeling and the simulation of the system which is composed by a PV generator, a boost converter, a Pulse Width Modulation and a DC motor.
- Programme pour la promotion des énergies renouvelables, de l’électrification rurale et de l’approvisionnement durable en combustibles domestiques. http://www.senegal-energies.com/index.php/outils-donnees/actu/175-programme-de-promotion-des-energies-renouvelables
- Barlaud, M., Sow, G. and Masselot, Ch. (1980) Alimentation d’une pompe immergée à partir d’un générateur photovoltaique à l’aide d’un onduleur triphasé à transistor. Revue de physique appliquée, 15, 263-269. https://doi.org/10.1051/rphysap:01980001502026300
- Equer, B. (1193) énergie Solaire Photovoltaique physique et technologie de la conversion photovoltaique, 1, édition ellipses, 231.
- Ndoye, S., Ly, I., Barro, F.I., Lemrabott, O.H. and Sissoko, G. (2009) Modélisation et simulation sous Matlab/Simulink da la chaine d’alimentation d’une station relais de télécommunications en énergie solaire PV dans une zone isolée du réseau électrique. Journal des Sciences, 9, 45-55.
- ISRA, ITA, CIRAD (2005) Bilan de la recherche agricole et agroalimentaire au Sénégal, 530p. ISRA: Institut Sénégalaise de Recherche Agricoles; ITA: Institut de Technologie Alimentaire; CIRAD: Centre de coopération Internationale en Recherche Agronomique pour le Développement.
- Wafa, B. (2012) Modélisation et simulation d’un système photovoltaique adapté par une commande MPPT, Mémoire de Master en Génie électrique.
- Abada,S. (2011) étude et optimisation d’un générateur photovoltaique pour la recharge d’une batterie avec un convertisseur SEPIC. Mémoire en Génie électrique, Faculté des sciences et Génie université LAVAL, QUEBEC
- Zahari, Z., et al.(2009) Modélisation des convertisseurs statiques DC-DC pour des applications dans les énergies Renouvelables en utilisant Matlab/Simulink. Conférence EF 2009 UTC, Compiègne
- Mabrouk, H., et al. (2014) étude de la technique d’optimisation sur le système de pompage photovoltaique au fil du soleil. Revue des énergies Renouvelables, 17, 579-588.