Passive Remediation of Acid Mine Drainage Using Ball-Milling Modified Indonesian Natural Bentonite: Laboratory Batch and Column Sorption of Manganese — Oak Academic Publishing
Research ArticleOpen AccessGoogle Scholar indexed
Passive Remediation of Acid Mine Drainage Using Ball-Milling Modified Indonesian Natural Bentonite: Laboratory Batch and Column Sorption of Manganese
Department of Environmental Engineering, Universitas Pembangunan Nasional “Veteran”, Yogyakarta, Indonesia
,
Department of International Development Engineering, Tokyo Institute of Technology, Tokyo, Japan
,
Department of International Development Engineering, Tokyo Institute of Technology, Tokyo, Japan
1 Department of Environmental Engineering, Universitas Pembangunan Nasional “Veteran”, Yogyakarta, Indonesia
2 Department of International Development Engineering, Tokyo Institute of Technology, Tokyo, Japan
3 Department of International Development Engineering, Tokyo Institute of Technology, Tokyo, Japan
Manganese (Mn) is an essential element for human body. However, elevated concentration of manganese causes severe problem and disease. Acid mine drainage (AMD), wastewater generated due to open-pit mining, commonly contains Mn with exceeded concentration. This study is to investigate the improvement of ball-milling modified Indonesian natural bentonite (INB) for manganese (Mn) removal from AMD and to increase the pH through batch and column sorption test as a passive treatment system approach. The batch sorption test result showed the maximum Mn adsorbed ( Q m ) on INB from the Langmuir model increased from 4.69 to 17.12 mg/g after milling. The column sorption test result also showed the amount of Mn adsorbed on INB until breakthrough time ( q u ) and until saturation time ( q ) increased after milling. The q u increased from 1.27 to 10.06 mg/g, and the q increased from 4.55 to 12.91 mg/g. The mass transfer zone (MTZ) became significantly shorter after milling from 0.22 to 0.07 cm. The Thomas model exhibited the equilibrium uptake of Mn ( q 0 ) increased after milling from 3.91 to 13.72 mg/g. In equilibrium condition, both unmilled and milled INB showed the pH increased from ≈3 to 8.
KeywordsBentoniteBall-MillingManganeseAcid Mine DrainageBatch and Column Sorption
Johnson, D.B. and Hallberg, K.B. (2005) Acid Mine Drainage Remediation Options: A Review. Science of the Total Environment, 338, 3-14. https://doi.org/10.1016/j.scitotenv.2004.09.002
Akcil, A. and Koldas, S. (2006) Acid Mine Drainage (AMD): Causes, Treatment and Case Studies. Journal of Cleaner Production, 14, 1139-1145. https://doi.org/10.1016/j.jclepro.2004.09.006
Ziemkiewicz, P.F., Brant, D.L. and Skousen, J.G. (1996) Acid Mine Drainage Treatment with Open Limestone Channels. Proceedings American Society of Mining and Reclamation, Knoxville, Tennessee, 19-25 May 1996, 367-374. https://doi.org/10.21000/JASMR96010367
Herniwanti, Priatmadi, J.B., Yanuwiadi, B. and Soemarno (2014) Characteristics of Acid Mine Water. International Journal of ChemTech Research, 6, 967-972.
Indonesian Ministry of Life Environment (2003) Standard Quality for Coal Mining Waste Water. Indonesia.
Bouchard, M., Laforest, F., Vandelac, L., Bellinger, D. and Mergler, D. (2007) Hair Manganese and Hyperactive Behaviors: Pilot Study of School Age Children Exposed Through Tap Water. Environmental Health Perspective, 115, 122-127. https://doi.org/10.1289/ehp.9504
Kondakis, X.G., Makris, N., Leotsinidis, M., Prinou, M. and Papapetropoulos, T. (1989) Possible Health Effects of High Manganese Concentrations in Drinking Water. Archives of Environmental Health, 44, 175-178. https://doi.org/10.1080/00039896.1989.9935883
Taylor, J., Pape, S. and Murphy, N. (2005) A Summary of Passive and Active Treatment Technologies for Acid and Metalliferous Drainage (AMD). Proceedings of the 5th Australian Workshop on Acid Drainage, Fremantle, Western Australia, 29-31 August 2005, 1-49.
Zipper, C., Skousen, J. and Jage, C. (2011). Passive Treatment of Acid-Mine Drainage. Virginia Cooperative Extension, 23, 1338-1345.
Budsaereechai, S., Kamwialisak, K. and Ngernyen, Y. (2012) Adsorption of Lead, Cadmium and Copper on Natural and Acid Activated Bentonite Clay. KKU Research Journal, 17, 800-810.
El Miz, M., et al. (2014) Characterization and Adsorption Study of Thymol on Pillared Bentonite. Open Journal of Physical Chemistry, 4, 98-116. https://doi.org/10.4236/ojpc.2014.43013
Vhahangwele, M. and Mugera, G.W. (2015) The Potential of Ball-Milled South African Bentonite Clay for Attenuation of Heavy Metals from Acidic Wastewaters: Simultaneous Sorption of Co2+, Cu2+, Ni2+, Pb2+, and Zn2+ Ions. Journal of Environmental Chemical Engineering, 3, 2416-2425. https://doi.org/10.1016/j.jece.2015.08.016
Djukic, A., Jovanovic, U., Tuvic, T., Andric, V., Grbovic Novakovic, J., Ivanovic, N. and Matovic, L. (2013) The Potential of Ball-Milled Serbian Natural Clay for Removal of Heavy Metal Contaminants from Wastewaters: Simultaneous Sorption of Ni, Cr, Cd and Pb Ions. Ceramics International, 39, 7173-7178. https://doi.org/10.1016/j.ceramint.2013.02.061
Bhattacharyya, K.G. and Sen, S. (2011) Removal of Cu (II) by Natural and Acid-Activated Clays: An Insight of Adsorption Isotherm, Kinetic and Thermodynamics. Desalination, 272, 66-75. https://doi.org/10.1016/j.desal.2011.01.001
Ramadan, A.R., Esawi, A.M.K. and Gawad, A.A. (2010) Effect of Ball Milling on the Structure of Na+-Montmorillonite and Organo-Montmorillonite (Cloisite 30B). Applied Clay Science, 47, 196-202. https://doi.org/10.1016/j.clay.2009.10.002
Christidis, G.E., Dellisanti, F., Valdre, G. and Makri, P. (2005) Structural Modifications of Smectites Mechanically Deformed under Controlled Conditions. Clay Minerals, 40, 511-522. https://doi.org/10.1180/0009855054040188
Lee, Y.C., Kuo, C.L., Wen, S.B. and Lin, C.P. (2007) Changes of Organo-Montmo- rillonite by Ball-Milling in Water and Kerosene. Applied Clay Science, 36, 265-270. https://doi.org/10.1016/j.clay.2006.09.013
Christidis, G.E., Makri, P. and Perdikatsis, V. (2004) Influence of Grinding on the Structure and Colour Properties of Talc, Bentonite and Calcite White Fillers. Clay Minerals, 39, 163-175. https://doi.org/10.1180/0009855043920128
Masindi, V., Gitari, M.W., Tutu, H. and DeBeer, M. (2015) Efficiency of Ball Milled South African Bentonite Clay for Remediation of Acid Mine Drainage. Journal of Water Process Engineering, 8, 227-240. https://doi.org/10.1016/j.jwpe.2015.11.001
Indonesian Ministry of Energy and Mineral Resource (2009) Book 3: Java Island, Indonesian Geological Resource, Indonesian Ministry of Energy and Mineral Resource, Indonesia.
Yulianti, A., Warmada, I.W. and Titisari, A.D. (2011) Characteristics and Genesis of Montmorilonitic Claystone from Bandung Area, Wonosegoro, Boyolali, Central Java, Indonesia. Journal of Southeast Asian Applied Geology, 3, 64-71.
Ake, C.L., et al. (2003) Porous Organoclay Composite for the Sorption of Polycyclic Aromatic Hydrocarbons and Pentachlorophenol from Groundwater. Chemosphere, 51, 835-844. https://doi.org/10.1016/S0045-6535(03)00040-7
Ake, C.L., Mayura, K., Huebner, H., Bratton, G.R. and Phillips, T.D. (2001) Development of Porous Clay-Based Composites for the Sorption of Lead from Water. Journal of Toxicology and Environmental Health, 63, 459-475. https://doi.org/10.1080/152873901300343489
Chapman, H.D. (1965) Cation Exchange Capacity. In: Black, C.A., Ed., Methods of Soil Analysis-Chemical and Microbiological Properties, American Society of Agronomy Inc., Madison, 891-901.
Do, D.D. (1998) Adsorption Analysis: Equilibira and Kinetics. Vol. 2, Imperial College Press, London.
Srasra, E., Bergaya, F. and Fripiat, J.J. (1994) Infrared Spectroscopy Study of Tetrahedral and Octahedral Substitutions in an Interstratified Illite-Smectite Clay. Clays and Clay Minerals, 42, 237-241. https://doi.org/10.1346/CCMN.1994.0420301
Tyagi, B., Chudasama, C.D. and Jasra, R.V. (2006) Determination of Structural Modification in Acid Activated Montmorillonite Clay by FT-IR Spectroscopy. Spectrochimica Acta—Part A: Molecular and Biomolecular Spectroscopy, 64, 273-278. https://doi.org/10.1016/j.saa.2005.07.018
Grim, R.E. (1968) Clay Mineralogy. McGraw Hill Book Company, New York, NY.
Essington, M.E. (2004) Soil and Water Chemistry: An Integrative Approach. CRC Press, Boca Raton. https://doi.org/10.1201/b12397
Blackmore, A.V. and Miller, R.D. (1961) Tactoid Size and Osmotic Swelling in Calcium Montmorillonite. Soil Science Society of America Journal, 25, 169-173. https://doi.org/10.2136/sssaj1961.03615995002500030009x
Prastistho, W., Kurniawan, W. and Hinode, H. (2018) Ball-Milling Effect on Indonesian Natural Bentonite for Manganese Removal from Acid Mine Drainage. MATEC Web of Conferences, 156, 1-5.
Sondi, I., Stubicar, M. and Pravdic, V. (1997) Surface Properties of Ripidolite and Beidellite Clays Modified by High-Energy Ball Milling. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 127, 141-149. https://doi.org/10.1016/S0927-7757(96)03893-9
Geankoplis, C.J. (1993) Transport Processes and Unit Operations. Prentice-Hall International, Inc., Upper Saddle River, NJ.
Thomas, H.C. (1944) Heterogeneous Ion Exchange in a Flowing System. Journal of the American Chemical Society, 66, 1664-1666. https://doi.org/10.1021/ja01238a017