Simulation and Measurements of VSWR for Microwave Communication Systems
- 1 Faculty of Information Technology, Polytechnic University of Tirana, Tirana, Albania
- 2 Faculty of Information Technology, Polytechnic University of Tirana, Tirana, Albania
- 3 Faculty of Information Technology, Polytechnic University of Tirana, Tirana, Albania
- 4 Faculty of Information Technology, Polytechnic University of Tirana, Tirana, Albania
Abstract
Nowadays, microwave frequency systems, in many applications are used. Regardless of the application, all microwave communication systems are faced with transmission line matching problem, related to the load or impedance connected to them. The mismatching of microwave lines with the load connected to them generates reflected waves. Mismatching is identified by a parameter known as VSWR (Voltage Standing Wave Ratio). VSWR is a crucial parameter on determining the efficiency of microwave systems. In medical application VSWR gets a specific importance. The presence of reflected waves can lead to the wrong measurement information, consequently a wrong diagnostic result interpretation applied to a specific patient. For this reason, specifically in medical applications, it is important to minimize the reflected waves, or control the VSWR value with the high accuracy level. In this paper, the transmission line under different matching conditions is simulated and experimented. Through simulation and experimental measurements, the VSWR for each case of connected line with the respective load is calculated and measured. Further elements either with impact or not on the VSWR value are identified. Interpretation of simulation and experimental results allows to judge about improving the VSWR, and consequently increasing the microwave transmission systems efficiency.
- A. Pekka, “Microwave Transmission-Line Networks for Backward-Wave Media and Reduction of Scattering,” TKK Radio Science and Engineering Publications, 2009.
- J. D. Kraus and R. J. Marhefka, “Antennas for All Applications,” 3rd Edition, McGraw Hill, New York, 2003.
- C. A. Balanis, “Antenna Theory Analysis and Design,” 2nd Edition, John Wiley & Sons, Inc., New York, 1997.
- Y. T. Lo and S. W. Lee, “Antenna Handbook, Theory, Applications, and Design,” Van Nostrand Reinhold, New York, 1988.
- W. Darrin, “Understanding SWR by Example,” Simulations, QST C ARRL, 2006.
- T. G. Spence, D. H. Werner and R. D. Groff, “Genetic Algorithm and Optimization of Some Novel Broadband and Multiband Microstrip Antennas,” The Department of Electrical Engineering, Pennsylvania State University, University Park, 2004.
- G. Bindu, A. Lonappan, V. Thomas, C. K. Aanandan and K. T. Mathew, “Active Microwave Imaging for Breast Cancer Detection,” Progress in Electromagnetics Research, Vol. 58, 2006, pp. 149-169. doi:10.2528/PIER05081802
- V. Vountesmeri and J. K. Rodriguez, “Magnetoresistive Power Sensor for Measurement in Situ of RF Power Absorbed by Tissue,” IEEE Transactions on Instrumentation and Measurement, Vol. 49, No. 3, 2000, pp. 513-516. doi:10.1109/19.850386
- M. Dogan and F. Ustuner, “A Telemetry Antenna System for Unmanned Air Vehicles,” Progress in Electromagnetics Research Symposium Proceedings, Cambridge, 5 July 2010.
- Jiri Polivka Spacek Labs, “Inc. High Frequency Electronics,” Summit Technical Media, LLC, 2007.
- P. O. Otasowie and E. A. Ogujor, “Voltage Standing Wave Ratio Measurement and Prediction,” International of Physical Sciences, Vol. 4, No. 11, 2009, pp. 651-656.
- Zh. Yang, et al., “A Simple and Accurate Measurement Method for WSVR of Waveguide to Coaxial Transitions,” International Conference on Measuring Technology and Mechanotronics Automation, Vol. 1, 2010, pp. 339-341.