Characterization and Classification of Rocks with Lamb Modes
- 1 Metrology Laboratory and Information Treatment, Department of physics, University Ibn Zohr, Agadir, Morocco
- 2 Metrology Laboratory and Information Treatment, Department of physics, University Ibn Zohr, Agadir, Morocco
- 3 Equip Petrology, Metallogeny and Materials, Department of Geology, University Ibn Zohr, Agadir, Morocco
- 4 Metrology Laboratory and Information Treatment, Department of physics, University Ibn Zohr, Agadir, Morocco
Abstract
The nondestructive investigation by ultrasound has become a fundamental tool for characterizing rocks. We applied this technique for characterizing samples of rocks. The later had been members of the following three big families of geogical classification: magmatic rocks, metamorphic rocks, sedimentary rocks. The method usually used is based on the measurement of ultrasound parameters, i.e. the longitudinal and transversal propagation velocities. The measurement of these parameters allows to determine the mechanical properties of each rock. These studies do not allow to find the three big axes of the rocks. In this work we show for each rock his corresponding ultrasonic signature by the use of his experimentally determined Lamb dispersion curves. The obtained results put in evidence that the descending slope of the Lamb modes is a reliable and efficient criterion for classifying rocks by ultrasound. This is an adequate solution for a good classification of rocks. It gives a high precision, it is reliable and quick and last not least cheap.
- G. Vasconcelos, “Ultrasonic Evaluation of the Physical and Mechanical Properties of Granites,” Ultrasonics, Vol. 48, No. 10, 2008, pp. 453-466. doi:10.1016/j.ultras.2008.03.008
- Y. Youash, “Dynamic Physical Properties of Rocks: Part 2, Experimental Result,” Proceedings of the 2nd Congress of the International Society for Rock Mechanics, Beograd, 21-26 September 1970, pp. 185-195.
- S. Kahraman and T. Yeken, “Determination of Physical Properties of Carbonate Rocks from P Wave Velocity,” Bulletin of Engineering Geology and the Environment, Vol. 67, No. 2, 2008, pp. 277-281.doi:10.1007/s10064-008-0139-0
- S. Kahraman, U. Ulker and S. Delibalta, “A Quality Classification of Building Stones from P-Wave Velocity and Its Application to Stone Cutting with Gang Saws,” Journal of the Southern African Institute of Mining and Metallurgy, Vol. 107, 2007, pp. 427-430.
- M. Inoue and M. Ohomi, “Relation between Uniaxial Compressive Strength and Elastic Wave Velocity of Soft Rock,” Proceedings of the International Symposium on Weak Rock, Tokyo, 21-24 September 1981, pp. 9-13.
- P. Gaviglio, “Longitudinal Waves Propagation in a Limestone: The Relationship between Velocity and Density,” Rock Mechanics and Rock Engineering, Vol. 22, No. 4, 1989, pp. 299-306. doi:10.1007/BF01262285
- F. K. Boadu, “Predicting the Transport Properties of Fractured Rocks from Seismic Information: Numerical Experiments,” Journal of Applied Geophysics, Vol. 44, No. 3, 2000, pp. 103-113. doi:10.1016/S0926-9851(99)00020-8,
- S. Kahraman, “A Correlation between P-Wave Velocity, Number of Joints and Schmidt Hammer Rebound Number,” International Journal of Rock Mechanics and Mining Sciences, Vol. 38, No. 5, 2001, pp. 729-733. doi:10.1016/S1365-1609(01)00034-X
- H. T. Ozkahraman, R. Selver and E. C Is?k, “Determination of the Thermal Conductivity of Rock from P-Wave Velocity,” International Journal of Rock Mechanics and Mining Sciences, Vol. 41, No. 4, 2004, pp. 703-708. doi:10.1016/j.ijrmms.2004.01.002
- E. Yasar and Y. Erdogan, “Correlating Sound Velocity with the Density, Compressive Strength and Young’s Modulus of Carbonate Rocks,” International Journal of Rock Mechanics and Mining Sciences, Vol. 41, No. 5, 2004, pp. 871-875. doi:10.1016/j.ijrmms.2004.01.012
- M. Khandelwal and P. G. Ranjith, “Correlating Index Properties of Rocks with P-Wave Measurements,” Journal of Applied Geophysics, Vol. 71, No. 2, 2010, pp. 1-5. doi:10.1016/j.jappgeo.2010.01.007