Optimization of Ilmenite Dissolution by Synergistic Effect of Oxalic Acid and Hydrochloric Acid for Preparing Synthetic Rutile — Oak Academic Publishing
Research ArticleOpen AccessGoogle Scholar indexed
Optimization of Ilmenite Dissolution by Synergistic Effect of Oxalic Acid and Hydrochloric Acid for Preparing Synthetic Rutile
Department of Chemistry, Faculty of Science, University of Guilan, Guilan, Iran
,
Department of Mining and Metallurgical Engineering, Amirkabir University of Technology, Tehran, Iran
,
Department of Physics and Chemistry, Faculty of Basic Sciences, Imam Ali University, Tehran, Iran
1 Department of Chemistry, Faculty of Science, University of Guilan, Guilan, Iran
2 Department of Mining and Metallurgical Engineering, Amirkabir University of Technology, Tehran, Iran
3 Department of Physics and Chemistry, Faculty of Basic Sciences, Imam Ali University, Tehran, Iran
This study was carried out to investigate the interaction of oxalic acid with hydrochloric acid to attain the better performance for iron dissolution in comparison to absence of oxalic acid. The effects of oxalic acid on ratio of hydrochloric acid, acid concentration, ratio of liquid to solid, temperature and dissolution time are investigated for the dissolution of Fe and Ti from ilmenite to produce synthetic rutile. The DX7 software basing on an experimental design method with the central composite of response surface design is applied to specify the effects of the parameters and to optimize the leaching process. The optimum condition was determined by analysis of variance (ANOVA), indicating that the ratio of oxalic acid to hydrochloric acid for Fe dissolution and acid concentration for Ti dissolution were the most effective parameters. The results showed that the dissolution of Fe and Ti in 30% (w/w) hydrochloric acid solution was only 48.65% and 5.14%, respectively, while at the same condition and in the presence of oxalic acid with twice the ratio, these values are increased to 78.65% and 12.06%, respectively. The optimum values of parameters were as follows: oxalic acid to hydrochloric acid ratio (2:1), acid concentration (30%), ratio of liquid to solid (10), temperature (160 °C), and dissolution time (3 h). By applying the optimized parameters, Fe and Ti dissolution of 97.15% and 2.8% were predicted by the software with a desirability of 0.745. The results of leaching tests indicated that the Fe and Ti dissolution of 97.58% and 2.43%, were achieved, respectively, which are very close to the predicted value.
Deer, W., Howie, R. and Zussman, J. (1992) An Introduction to the Rock-Forming Minerals. Vol. 2. Longman Scientific & Technical, Hong Kong.
Didenko, P. and Efremov, A. (2004) SIMS Study of Self-Consisted Fractionation of Iron and Titanium Isotopes in Ilmenite. Applied Surface Science, 231, 903-906. https://doi.org/10.1016/j.apsusc.2004.03.165
Pownceby, M., Sparrow, G. and Fisher-White, M. (2008) Mineralogical Characterisation of Eucla Basin Ilmenite Concentrates—First Results from a New Global Resource. Minerals Engineering, 21, 587-597. https://doi.org/10.1016/j.mineng.2007.11.011
Nafziger, R. and Elger, G. (1987) Preparation of Titanium Feedstock from Minnesota Ilmenite by Smelting and Sulfation-Leaching. US Bureau of Mines. Report of Investigation, 9065.
Walpole, E. (1997) The Austpac ERMS and EARS Processes. A Cost Effective Route to High Grade Synthetic Rutile and Pigment Grade TiO2. Heavy Minerals, 169-174.
Samal, S. (2016) Synthesis and Characterization of Titanium Slag from Ilmenite by Thermal Plasma Processing. JOM, 68, 2349-2358. https://doi.org/10.1007/s11837-016-1817-1
Kotzé, H., Bessinger, D. and Beukes, J. (2006) Ilmenite Smelting at Ticor SA. Journal of the South African Institute of Mining and Metallurgy, 106, 165-170.
Balderson, G. and Macdonald, C. (1999) Method for the Production of Synthetic Rutile. Tiomin Resources, Inc., Assignee. US Patent 5885324.
Sinha, H. (1979) Proceedings of the Eleventh Commonwealth Mining and Metallurgical Congress. Institute of Mining and Metallurgy, London, 669-672.
Lalasari, L.H., Subagja, R., Yuwono, A.H., Firdiyono, F., Harjanto, S. and Suharno, B. (2013) Sulfuric Acid Leaching of Bangka Indonesia Ilmenite Ore and Ilmenite Decomposed by NaOH. Advanced Materials Research, 789, 522-530. https://doi.org/10.4028/www.scientific.net/AMR.789.522
Baba, A., Swaroopa, S., Ghosh, M. and Adekola, F. (2013) Mineralogical Characterization and Leaching Behavior of Nigerian Ilmenite Ore. Transactions of Nonferrous Metals Society of China, 23, 2743-2750. https://doi.org/10.1016/S1003-6326(13)62792-2
Zhang, W., Zhu, Z. and Cheng, C. (2011) A Literature Review of Titanium Metallurgical Processes. Hydrometallurgy, 108, 177-188. https://doi.org/10.1016/j.hydromet.2011.04.005
Nayl, A. and Aly, H. (2009) Acid Leaching of Ilmenite Decomposed by KOH. Hydrometallurgy, 97, 86-93. https://doi.org/10.1016/j.hydromet.2009.01.011
Zhang, L., Hu, H., Wei, L., Chen, Q. and Tan, J. (2010) Hydrochloric Acid Leaching Behaviour of Mechanically Activated Panxiilmenite (FeTiO3). Separation and Purification Technology, 73, 173-178. https://doi.org/10.1016/j.seppur.2010.03.022
Nayl, A., Awwad, N. and Aly, H. (2009) Kinetics of Acid Leaching of Ilmenite Decomposed by KOH: Part 2. Leaching by H2SO4 and C2H2O4. Journal of Hazardous Materials, 168, 793-799. https://doi.org/10.1016/j.jhazmat.2009.02.076
Imahashi, M. and Takamatsu, N. (1976) The Dissolution of Titanium Minerals in Hydrochloric and Sulfuric Acids. Bulletin of the Chemical Society of Japan, 6, 1549-1553. https://doi.org/10.1246/bcsj.49.1549
Xu, S. and Huang, Z.S. (1993) The Kinetics of Panzhihua Ilmenite Leaching with Sulfuric Acid. Mining and Metallurgical Engineering, 13, 44-48.
Martínez-Luévanos, A., Rodriguez-Delgado, M.G., Uribe-Salas, A., Carrillo-Pedroza, F.R. and Osuna-Alarcón, J.G. (2011) Leaching Kinetics of Iron from Low Grade Kaolin by Oxalic Acid Solutions. Applied Clay Science, 51, 473-477. https://doi.org/10.1016/j.clay.2011.01.011
Veglio, F., Passariello, B., Barbaro, M., Plescia, P. and Marabini, A.M. (1998) Drum Leaching Tests in Iron Removal from Quartz Using Oxalic and Sulphuric Acids. International Journal of Mineral Processing, 54, 183-200. https://doi.org/10.1016/S0301-7516(98)00014-3
Jonglertjunya, W., Rattanaphan, S. and Tipsak, P. (2014) Kinetics of the Dissolution of Ilmenite in Oxalic and Sulfuric Acid Solutions. Asia-Pacific Journal of Chemical Engineering, 9, 24-30. https://doi.org/10.1002/apj.1742
Ilhan, S., Kalpakli, A.O., Kahruman, C. and Yusufoglu, I. (2013) The Investigation of Dissolution Behavior of Gangue Materials during the Dissolution of Scheelite Concentrate in Oxalic Acid Solution. Hydrometallurgy, 136, 15-26. https://doi.org/10.1016/j.hydromet.2013.02.013
Lee, S., Tran, T., Park, Y.Y., Kim, S.J. and Kim, M.J. (2006) Study on the Kinetics of Iron Oxide Leaching by Oxalic Acid. International Journal of Mineral Processing, 80, 144-152. https://doi.org/10.1016/j.minpro.2006.03.012
Chen, H. and Grassian, V. (2013) Iron Dissolution of Dust Source Materials during Simulated Acidic Processing: The Effect of Sulfuric, Acetic, and Oxalic Acids. Environmental Science & Technology, 47, 10312-10321.
Haaland, D. (1989) Experimental Design in Biotechnology. Marcel Dekker Inc., New York.
Montgomery, D. (1991) Design and Analysis of Experiments. 3rd Edition, John Wiley and Sons, New York.
Mannan, S., Fakhru’l-Razi, A. and Alam, M. (2007) Optimization of Process Parameters for the Bioconversion of Activated Sludge by Penicillium corylophilum, Using Response Surface Methodology. Journal of Environmental Sciences, 19, 23-28. https://doi.org/10.1016/S1001-0742(07)60004-7
Anderson, M.J. and Whitcomb, P.J. (2000) DOE Simplified: Practical Tools for Effective Experimentation. Quality and Reliability Engineering International, Oregon.
Vogel, A.I. (1978) A Textbook of Quantitative Inorganic Analysis. 4th Edition, Longman, London.
Lasheen, T. (2005) Chemical Benefication of Rosetta Ilmenite by Direct Reduction Leaching. Hydrometallurgy, 76, 123-129. https://doi.org/10.1016/j.hydromet.2004.10.002
Suter, D., Siffert, C., Sulzberger, B. and Stumm, W. (1988) Catalytic Dissolution of Iron (III) (Hydr)oxides by Oxalic Acid in the Presence of Fe (II). Naturwissenschaften, 75, 571-573. https://doi.org/10.1007/BF00377723
El-Hazek, N., Lasheen, T., El-Sheikh, R. and Zaki, S.A. (2007) Hydrometallurgical Criteria for TiO2 Leaching from Rosetta Ilmenite by Hydrochloric Acid. Hydrometallurgy, 87, 45-50. https://doi.org/10.1016/j.hydromet.2007.01.003
Sasikumar, C., Rao, D., Srikanth, S., Mukhopadhyay, N.K. and Mehrotra, S.P. (2007) Dissolution Studies of Mechanically Activated Manavalakurichi Ilmenite with HCl and H2SO4. Hydrometallurgy, 88, 154-169. https://doi.org/10.1016/j.hydromet.2007.03.013
Van Dyk, J., Vegter, N. and Pistorius, P. (2002) Kinetics of Ilmenite Dissolution in Hydrochloric Acid. Hydrometallurgy, 65, 31-36. https://doi.org/10.1016/S0304-386X(02)00063-4
Mehdilo, A. and Irannajad, M. (2012) Iron Removing from Titanium Slag for Synthetic Rutile Production. Physicochemical Problems of Mineral Processing, 48, 425-439.
Mahmoud, M., Afifi, A. and Ibrahim, I. (2004) Reductive Leaching of Ilmenite Ore in Hydrochloric Acid for Preparation of Synthetic Rutile. Hydrometallurgy, 73, 99-109. https://doi.org/10.1016/j.hydromet.2003.08.001