This study deals with the physico-chemical, mineralogical and geotechnical characterization of alluvial clays from Batchenga in Cameroon with a view to their use as building materials for housing. The alluvial clay (Arg.All) was collected in the locality of Batchenga at the village Natchigal (4 ˚ 20'40''N and 11 ˚ 37'40''E at 378 m altitude) and was fired between 900˚C and 1100˚C. Characterization was performed by XRD, XRF, DTA/DTG, and firing tests. XRD, XRF, DTA/DTG infrared analysis methods were performed on these clays. The linear shrinkage, mechanical strengths, water absorption, porosity and density were measured on the fired products. The results obtained show that the major oxides are for the Arg.Lat SiO 2 (72.13%), Al 2 O 3 (14.1%), Fe 2 O 3 (4.45%) and for the Arg.All: SiO 2 (48.91%), Al 2 O 3 (23.79%), Fe 2 O 3 (9.54%). The fired products based on alluvial clay, present the flexural strength of 4.45 MPa at 900˚C and 6.80 MPa at 1100˚C. As for those based on lateritic clay, the flexural strength is 0.53 and 0.76 MPa respectively at 900 and 1100˚C. The porosity is 33.69% at 900˚C and 22.93% at 1100˚C for the alluvial clay and 39.55% at 900˚C and 36.01% for the lateritic clay at 1100˚C. Water absorption is 18% to 11.16% for alluvial clay and 22.43% to 21.16% for lateritic clay at 900˚C and 1100˚C respectively. These results suggest that alluvial clay and its firing products have better physico-chemical, geotechnical and mechanical characteristics regardless of the firing temperature of the manufactured products. The addition of degreaser is recommended to improve the mechanical performance of lateritic clay.
KeywordsClaysFired ProductsFiring TemperaturePhysical and Mechanical PropertiesMicrostructure
Millot, G.J.P. (1964) Géologie des Argiles. Masson et Cie, Echandens, 499.
Taallah, B., Guettala, A., Guettala, S. and Kriker, A. (2014) Mechanical Properties and Hygroscopicity Behavior of Compressed Earth Block Filled by Date Palm Fibers. Construction and Building Materials, 59, 161-168. https://doi.org/10.1016/j.conbuildmat.2014.02.058
Mimboe, A.G., Abo, M.T., Djobo, J.N.Y., Tome, S., Kaze, R.C. and Deutou, J.G.N. (2020) Lateritic Soil Based-Compressed Earth Bricks Stabilized with Phosphate Binder. Journal of Building Engineering, 31, Article ID: 101465. https://doi.org/10.1016/j.jobe.2020.101465
Ngon, N. (2007) Etude morphologique, minéralogique, géochimique et cristallographique des argiles latéritiques et des argiles hydromorphes de la région de Yaoundé en zone tropicale humide. Essais industriel et evaluation de leurs potentialités comme matériaux de construction. Université de Yaoundé I, Cameroun.
Ntouala, R. (2014) Produits d’altération des schistes et argiles alluviales de la série d’Ayos à Akok-Maka (Est-Cameroun): Minéralogie, géochimie et valorisation agropédologique et géotechnique. Thèse Doctorat Ph-D, Faculté des Sciences, Université de Yaoundé I, Cameroun.
Mbumbia, L., Mertens de Wilmars, A. and Tirlocq, J. (2000) Performance Characteristics of Lateritic Soil Bricks Fired at Low Temperatures: A Case Study of Cameroon. Construction and Building Materials, 14, 121-131. https://doi.org/10.1016/S0950-0618(00)00024-6
Ngon, G.F.N., Etame, J., Ntamak-Nida, M.J., Mbog, M.B., Mpondo, A.M.M., Gérard, M., Yongue-Fouateu, R. and Bilong, P. (2012) Geological Study of Sedimentary Clayey Materials of the Bomkoul Area in the Douala Region (Douala Sub-Basin, Cameroon) for the Ceramic Industry. Comptes Rendus Geoscience, 344, 366-376. https://doi.org/10.1016/j.crte.2012.05.004
Thibault, P. and Le Berre, P. (1985) Les argiles pour brique. Vol. 65, Bureau de Recherches Géologiques et Minières, Orléans.
Kamseu, E., Kaze, C.R., Fekoua, J.N.N., Melo, U.C., Rossignol, S. and Leonelli, C. (2020) Ferrisilicates Formation during the Geopolymerization of Natural Fe-Rich Aluminosilicate Precursors. Materials Chemistry and Physics, 240, Article ID: 122062. https://doi.org/10.1016/j.matchemphys.2019.122062
Kaze, C.R., Nana, A., Lecomte-Nana, G.L., Deutou, J.G.N., Kamseu, E., Melo, U.C., Andreola, F. and Leonelli, C. (2022) Thermal Behaviour and Microstructural Evolution of Metakaolin and Meta-Halloysite-Based Geopolymer Binders: A Comparative Study. Journal of Thermal Analysis and Calorimetry, 147, 2055-2071. https://doi.org/10.1007/s10973-021-10555-2
Kaze, R.C., Beleuk à Moungam, L.M., Fonkwe Djouka, M.L., Nana, A., Kamseu, E., Chinje Melo, U.F. and Leonelli, C. (2017) The corrosion of Kaolinite by Iron Minerals and the Effects on Geopolymerization. Applied Clay Science, 138, 48-62. https://doi.org/10.1016/j.clay.2016.12.040
Mbey, J.A. (2013) Films composites amidon de manioc-kaolinite: influence de la dispersion de l’argile et des interactions argile-amidon sur les propriétés des films. Université de Lorraine, Lorraine.
Fadil-Djenabou, S., Ndjigui, P.-D. and Mbey, J.A. (2015) Mineralogical and Physicochemical Characterization of Ngaye Alluvial Clays (Northern Cameroon) and Assessment of Its Suitability in Ceramic Production. Journal of Asian Ceramic Societies, 3, 50-58. https://doi.org/10.1016/j.jascer.2014.10.008
Youmoue, M., Fongang, R.T.T., Sofack, J.C., Kamseu, E., Melo, U.C., Tonle, I.K., Leonelli, C. and Rossignol, S. (2017) Design of Ceramic Filters Using Clay/Sawdust Composites: Effect of Pore Network on the Hydraulic Permeability. Ceramics International, 43, 4496-4507. https://doi.org/10.1016/j.ceramint.2016.12.101
Nzeugang Nzeukou, A., Fagel, N., Njoya, A., Beyala, Kamgang, V., Eko Medjo, R., and Chinje Melo, U. (2013) Mineralogy and Physico-Chemical Properties of Alluvial Clays from Sanaga Valley (Center, Cameroon): Suitability for Ceramic Application. Applied Clay Science, 83-84, 238-243. https://doi.org/10.1016/j.clay.2013.08.038
Nzeukou Nzeugang, A., Medjo Eko, R., Fagel, N., Kamgang Kabeyene, V., Njoya, A., Balo Madi, A., Mache, J.R. and Melo Chinje, U. (2013) Characterization of Clay Deposits of Nanga-Eboko (Central Cameroon): Suitability for the Production of Building Materials. Clay Minerals, 48, 655-662. https://doi.org/10.1180/claymin.2013.048.4.18
Deutou, N.J.G., Beda, T., Biesuz, M., Boubakar, L., Melo, U.C., Kamseu, E. and Sglavo, V.M. (2018) Design and Characterization of Porous Mullite Based Semi-Vitrified Ceramics. Ceramics International, 44, 7939-7948. https://doi.org/10.1016/j.ceramint.2018.01.232
Deutou, J.N.G., Kamga, V.E.L.S., Kaze, R.C., Kamseu, E. and Sglavo, V.M. (2020) Thermal Behaviour and Phases Evolution during the Sintering of Porous Inorganic Membranes. Journal of the European Ceramic Society, 40, 2151-2162. https://doi.org/10.1016/j.jeurceramsoc.2020.01.035
Deutou, J.N.G., Zounedou, N., Kaze, R.C., Mohamed, H., Beda, T., Melo, U.C., Kamseu, E. and Sglavo, V.M. (2019) Semi-Vitrified Porous Kyanite Mullite Ceramics: Young Modulus, Microstructure and Pore Size Evolution. SN Applied Sciences, 2, Article No. 126. https://doi.org/10.1007/s42452-019-1902-5
Ekodeck, G.E. (1984) L’altération des roches métamorphiques du Sud Cameroun et ses aspects géotechniques. Doctral Thesis, Scientific and Medical University of Grenoble, Grenoble.
Vallerie, M. (1995) La pédologie: Planche 2. In: Atlas régional Sud-Cameroun, Office de la recherche scientifique et technique outre-mer, Yaoundé, 6-7.
Nzenti, J.P., Barbey, P., Macaudiere, J. and Soba, D. (1988) Origin and Evolution of the Late Precambrian High-Grade Yaounde Gneisses (Cameroon). Precambrian Research, 38, 91-109. https://doi.org/10.1016/0301-9268(88)90086-1
Burrough, P.A. (2001) Fractals in Soil Science. European Journal of Soil Science, 52, 527-528. https://doi.org/10.1046/j.1365-2389.2001.00418-10.x
Kakali, G., Perraki, T., Tsivilis, S. and Badogiannis, E. (2001) Thermal Treatment of Kaolin: The Effect of Mineralogy on the Pozzolanic Activity. Applied Clay Science, 20, 73-80. https://doi.org/10.1016/S0169-1317(01)00040-0
Ntouala, R.F.D., Onana, V.L., Kamgang, V. and Ekodeck, G.E. (2016) Mineralogical, Geochemical and Mechanical Characterization of the Ayos (East-Cameroon) Lateritic and Alluvial Clayey Mixtures: Suitability for Building Application. Journal of Building Engineering, 5, 50-56. https://doi.org/10.1016/j.jobe.2015.11.007
Nyassa Ohandja, H., Ntouala, R.F.D., Onana, V.L., Ngo’o Ze, A., Ndzié Mvindi, A.T. and Ekodeck, G.E. (2020) Mineralogy, Geochemistry and Physico-Mechanical Characterization of Clay Mixtures from Sa’a (Center Cameroon): Possibly Use as Construction Materials. SN Applied Sciences, 2, 1687. https://doi.org/10.1007/s42452-020-03365-y
Souza, G., Sánchez, R. and De Holanda, J.J.C. (2002) Characteristics and Physical-Mechanical Properties of Fired Kaolinitic Materials. Ceramica, 48, 102-107. https://doi.org/10.1590/S0366-69132002000200009
Diao, I., Diagne, M. and Dia, I. (2021) Applications, Characterization of Fired Clay Bricks for an Economic Contribution of the Exploitation of Thicky Clay Deposit. Materials Sciences and Applications, 12, 389-416. https://doi.org/10.4236/msa.2021.129027
Voula, R.M., Diamouangana, F.Z.M., Moutou, J.-M., Samba, V.I.B., Foutou, M.P. and Ngoma, M. (2021) Characterization, and Engineering, Characterization and Valuation of a Clay Soil Sampled in Londéla-Kayes in the Republic of Congo. Journal of Minerals and Materials Characterization and Engineering, 9, 117-133. https://doi.org/10.4236/jmmce.2021.92009
Nzeukou, N.A., Traina, K., Medjo, E.R., Kamseu, E., Njoya, A., Melo, U.C., Kamgang, B.V., Cloots, R. and Fagel, N. (2014) Mineralogical and Physical Changes during Sintering of Plastic Red Clays from Sanaga Swampy Valley, Cameroon. Interceram - International Ceramic Review, 63, 186-192. https://doi.org/10.1007/BF03401056