Design of a Diesel Fired Heat-Treatment Furnace
- 1 Department of Metallurgical and Materials Engineering Federal University of Technology, Akure, PMB 704, Nigeria
- 2 Department of Metallurgical and Materials Engineering Federal University of Technology, Akure, PMB 704, Nigeria
Abstract
This research is centered on the design of a diesel fired heat-treatment furnace using locally sourced materials. The design philosophy is to eliminate the use of heating elements requiring electric power which is poorly supplied in the country. Design drawings were produced and mild steel was used for the fabrication of the furnace casing, while the other components needed for the design were selected based on functionality, durability, cost and local availability. The furnace was assembled by lining the inner wall of the casing with refractory blocks made from heated mixture of kaolin, clay, sawdust and water after which the inner pot and electro technical devices (temperature controller, light indicator etc) were positioned. Testing was subsequently performed to evaluate the performance of the furnace. It was observed that the furnace has a fast heating rate (61.24℃/min to attain a pre-set temperature of 900℃); and a fuel consumption rate less than 1.41litres/hr. It was also observed that the furnace has good heat retaining capacity; can be easily maintained and safe for use.
- Dossee, T. and Boyer, H. Practical Heat Treating. Journal of Materials Processing Technology, 1997, 14(7): 235-257.
- George, E. Totten: Steel Heat Treatment Handbook, 2 nd Edition; 2002, pp 91-105.
- Netsushori, K.: Various Heat Treatment Technology. Trends and prospects of heat treatment in 21 st Century. 3 rd Edition. 1998, pp. 201-233.
- Olanrewaju, S.O.: Practical approach to metal hardening in our metallurgical industries, NMS Conference, National Metallurgical Development Center (NMOC), Jos, 2000, pp 6- 15.
- Oyawale, F. A. (2007): Design and Prototype development of a mini-Electric Arc Furnace. Pacific Journal of Science and Technology. 2007, 8(1):12 – 16.
- Bundgardt, K., Brandis, H. and Kroy, P. Salt Bath Carburizing and Case Hardened Steels at 900℃ – 1000℃., Harterei-technical publisher, 1994,19(3): 146-153.
- Fairbanks, L.H. and Palthorpe, L.G.W.: Controlled Atmospheres for Heat Treatment of Metals. Revised Edition; Iron and Steel Institutes, Spain. 1998, pp. 45-60.