Experimental Investigation of Woven E-Glass Epoxy Composite Laminates Subjected to Low-Velocity Impact at Different Energy Levels
- 1 Department of Production Engineering, National Institute of Technology,Tiruchirappalli - 15, India
- 2 Department of Production Engineering, National Institute of Technology,Tiruchirappalli - 15, India
Abstract
This work presents the results of an experimental investigation concerning the low-velocity impact response of woven glass fiber epoxy matrix composite laminates. Experimental tests were performed according to ASTM standards using an instrumented falling weight impact testing machine. Impact tests were conducted to characterize the type and extent of the damages observed in laminate subjected to different impact velocities: 2 to 4.5 m/sec. The response of these laminates to drop-weight low velocity impact at energy levels ranging from 3 to 15 J was investigated. At impact velocity of 4.429 m/sec, there is clearly a catastrophic failure of laminates. It was found that the laminates exhibited two types of failure modes viz., crack initiation and perforation of the laminate.
- Abrate S., (1991), Impact on laminated Composite Materials, Appl. Mech. Rev., 44 (4), 155–189.
- Cantwell WJ, Morton J., (1991), The impact resistance of composite materials - A review, Composites Part A, 22, 347–62.
- Richardson MOW, Wisheart MJ, (1996), Review of low-velocity impact properties of composite materials, Composites Part A, 27A, 1123–31.
- Bibo GA, Hogg PJ, (1996), Review - The role of reinforcement architecture on impact damage mechanisms & post-impact compression behavior, J. Mater. Sci., 31, 1115–37.
- N.K. Naik et al., (2000), Damage in woven-fabric composites subjected to low-velocity impact, Compos. Sci. Technol., 60, 731-744.
- Z.Y. Zhang, M.O.W. Richardson, (2007), Low velocity impact induced damage evaluation and its effect on the residual flexural properties of pultruded GRP composites, Compos. Struct., 81, 195–201.
- Davies GAO, Hitchings D, Zhou G, (1996), Impact damage and residual strengths of woven fabric glass/polyester laminates, Composites Part A, 27A, 1147-56.
- Lifshitz JM, Gandelsman M., (1997), Effect of near-surface impact-induced damage on the residual strength of woven glass/epoxy composite beams, Compos. Sci. Technol. 57, 205-16
- Karaoglan L, Noor AK, (1997), Frictional contact/impact response of textile composite structures, Compos. Struct. 37, 269-80.
- Ebeling T, Hiltner A, Baer E, Fraser IM, Orton ML, (1997), Delamination failure of a woven glass fiber composite, J. Compos. Mater., 31, 1318-33.
- Hirai Y, Hamada H, Kim JK., (1998), Impact response of woven glass fabric composites – I, effect of fiber surface treatment, Compos. Sci. Technol. 58, 91-104.
- Hirai Y, Hamada H, Kim JK., (1998), Impact response of woven glass fabric composites – II, effect of temperature, Compos. Sci. Technol. 58, 119-28
- Wu E, Chang LC, (1998), Loading rate effect on woven glass laminated plates by penetration force, J. Compos. Mater., 32, 702-21.
- Siow YP, Shim VPW, (1998), An experimental study of low velocity impact damage in woven fiber composites, J. Compos. Mater., 32, 1178-202.
- ASTM D 3029, (1982), Standard test method for impact resistance of rigid plastic sheeting or parts by means of a tup (Falling Weight), Philadelphia, American Society for Testing and Materials.