Thermal, Hardness and Microstructural Characterization of Al-Si-SiC<sub>p</sub> Composites
- 1 Department of Materials Science and Engineering, O.A.U., Ile-Ife. Nigeria.
- 2 Department of Materials Science and Engineering, O.A.U., Ile-Ife. Nigeria.
- 3 Center for Energy, Research and Development, Obafemi Awolowo University, Ile-Ife. Nigeria.
- 4 Department of Materials and Metallurgy, University of Birmingham, B15 2TT, United Kingdom.
Abstract
This study investigated the effects of silicon and silicon carbide particles contents on the thermal, hardness and microstructural behaviour of Al-Si-SiCp composites. 16 samples of the composite produced by stir casting technique were of silicon contents of 1, 2, 3 and 4% by weigh, and silicon carbide contents of 0.5, 1, 1.5 and 2% by weight for each composition of silicon. Each of the samples were subjected to homogenizing annealing heat treatment. Differential thermal analysis (DTA), hardness test and microstructural analysis were then performed on the samples from each composition. The results obtained showed that the hardness of the composite increased gradually as the silicon and silicon carbide particles content increased. The micrographs obtained revealed the presence of silicon carbide, silicon precipitates and aluminium carbide (Al 4 C 3 ) within the metallic matrix. The amounts of these phases varied with the silicon and silicon carbide content. All the samples gave DTA curves with major endothermic peaks between 550 – 570℃ and two sets of exothermic peaks between 580 – 610℃ for the first set and between 565 – 570℃ for the second set. It was inferred from the study that although varied silicon and silicon carbide contents affected the thermal, hardness and microstructural behaviour of the Al-Si-SiC p composites, the variation of the SiC p content had a more pronounced effect on the hardness value of the Al-Si-SiC p composite.
- Aigbodion, V.S. and Hassan, S.B. (2006): “ Effects of Silicon Carbide Reinforcement on Microstructure and Properties of Cast Al-Si-Fe/SiC Particulate Composites” Materials Science and Engineering A, Vol. 447, Issues 1-2, pp 355-360.
- Guiqing, C. ,Rubin, Z., Xinghong, Z. and Wenbo, H.(2010): “Microstructure and Properties of Hot Pressed Zr2(Al(Si)4C5/SiC Composites” Microelectronics International, Vol. 27, No. 1, pp21-24.
- Kelly, A. and Davies, G.J.(1965): “The Principles of the Fibre Reinforcement of Metal,” Rev. Vol.10, No. 37, p 1.
- Lai, S and Chung D.L.(1994): “Fabrication of Particulate Aluminium-matrix Composites by Liquid Metal Infiltration”. Journal of Materials Science, Vol. 29, pp 3128–3150.
- Manoj, S., Dwivedi, D. D., Lakhvir, S. and Vikas, C. (2009): “Development of Aluminium Based Silicon Carbide Particulate Metal Matrix Composite”. Journal of Minerals and Materials Characterization and Engineering, Vol. 8, No. 6, pp 455-467.
- Pay, Y and Deborah, D.L.(1995): “Powder Metallurgy Fabrication of Metal Matrix Composites Using Coated Fillers”, The International Journal of Powder Metallurgy, Vol.31, No. 4, Pp 335-390.
- Viala, J. C., Fortier, P. and Bouix, J. (1990): "Stable and Metastable Phase Equilibria in the. Chemical Interaction between Aluminium and Silicon Carbide", Journal of Materials Science, Vol. 25, pp 1842.