Coal Chemistry and Morphology of Thar Reserves,Pakistan
- 1 Fuel Research Centre, Pakistan Council of Scientific & Industrial Research, Karachi, Pakistan
- 2 Department of Chemistry, University of Karachi, Karachi, Pakistan
- 3 Scientific Information Centre, Pakistan Council of Scientific & Industrial Research, Karachi, Pakistan
Abstract
The surface of Thar coal has been characterized by spectroscopic, microscopic and chemical methods using atomic absorption spectroscopy, fourier transform infrared analysis, X-ray diffraction, scanned electron microscopy and pH titration. The samples contained high moisture, low volatile and low to moderate sulfur content and ranked as lignite (heating value 2541 - 4289 btu/lb on moist, mineral-matter-free basis). Scanned electron micrographs show porous matrix with calcium, potassium or sodium minerals. Fourier transform infrared analysis confirmed the presence of aluminum, silica and hydrate mineral constituents also. The spectra showed C=C aromatic groups at 1604 - 1609 cm -1 . Phenolic ester and carboxylic acid are identified by C=O stretching vibration peaks at 1702 cm -1 . The peaks of quartz and kaolinite were observed at 900 - 1100 cm -1 . Point of zero charge of Thar coal has been estimated as 6.00 to 6.27 through adsorption of H + and OH - ions by suspending coal particles in aqueous electrolyte solution. Oxygen containing functional groups, mineral matter, and metal oxides are found to have a remarkable impact on point of zero charge. The surface characterization study will be helpful in the separation of hydrophilic impurities during coal preparation processes considering pzc as the controlling factor
- A. Das, B. Sarkar and S. P. Mehrotra, “Prediction of Separation Performance of Floatex Density Separator for Processing of Fine Coal Particles,” International Journal of Mineral Processing, Vol. 91, No. 1-2, 2009, pp. 41-49.
- A. U. Kurniawan, O. Ozdemir, A. V. Nguyen, P. Ofori and B. Firth, “Flotation of Coal Particles in MgCl2, NaCl, and NaClO3 Solutions in the Absence and Presence of Dowfroth 250,” International Journal of Mineral Processing, Vol. 98, No. 3-4, 2011, pp. 137-144. doi:10.1016/j.minpro.2010.11.003
- X. Li, R. Shaw and P. Stevenson, “Effect of Humidity on Dynamic Foam Stability,” International Journal of Mineral Processing, Vol. 94, No. 1-2, 2010, pp. 14-19. doi:10.1016/j.minpro.2009.10.002
- K. S. Birdi, “Handbook of Surface and Colloid Chemistry,” 3rd Edition, CRC Press, Taylor & Francis Group, Boca Raton, London, New York, 2009, pp. 655-679.
- Y. D. Abreu, P. Patil, A. I. Marquez and G. G. Botte, “Characterization of Electroxidized Pittsburgh No. 8 Coal,” Fuel, Vol. 86, No. 4, 2007, pp. 573-584. doi:10.1016/j.fuel.2006.08.021
- V. Bouska and J. Pesek, “Quality Parameters of Lignite of the North Bohemian Basin in the Czech Republic in Comparison with the World Average Lignite,” International Journal of Coal Geology, Vol. 40, No. 2-3, 1999, pp. 211-235. doi:10.1016/S0166-5162(98)00070-6
- S. E. Kuh and D. S. Kim, “Effects of Surface Chemical and Electrochemical Factors on the Dewatering Characteristics of Fine Particle Slurry,” Journal of Environmental Science and Health. Part A: Toxic/Hazardous Substances & Environmental Engineering, Vol. 39, No. 8, 2004, pp. 2157-2182. doi:10.1081/ESE-120039382
- M. Kosmulski, “pH-Dependent Surface Charging and Points of Zero Charge. IV. Update and New Approach,” Journal of Colloid and Interface Science, Vol. 337, No. 2, 2009, pp. 439-448. doi:10.1016/j.jcis.2009.04.072
- M. N. Khan and A. Sarwar, “Determination of Points of Zero Charge of Natural and Treated Adsorbents,” Surface Review and Letters, Vol. 14, No. 3, 2007, pp. 461-469. doi:10.1142/S0218625X07009517
- A. Sarwar, M. N. Khan and K. F. Azhar, “Kinetic Studies of Pyrolysis and Combustion of Thar Coal by Thermo-gravimetry and Chemometric Data Analysis,” Journal of Thermal Analysis and Calorimetry, Vol. 109, No. 1, 2012, pp. 97-103. doi:10.1007/s10973-011-1725-0
- R. C. Carpenter and H. Diederichs, “Experimental Engi-neering,” 8th Edition, Wiley, New York, 1913.