Cycloidal Magnetic Gear Speed Reducer
- 1 Instituto de Ingenieria, Universidad Nacional Autonoma de Mexico, Mexico City, Mexico
Abstract
A cycloidal speed reducer employing gears with permanent magnets acting as teeth is described. The magnets, which have their axes radially oriented in both the orbiting gear and the fixed internal gear, are inserted in holes drilled in non magnetic rims without protruding from the cylindrical exposed surfaces. Because the orbiting gear is not restrained ra dially, it contacts the fixed gear and rolls on its inner surface. A normal force is developed at the contact point between the gears to balance the magnetic attraction and the centrifugal force of the orbiting gear. The friction available due to this normal force increases the transmission’s torque capacity, which is further increased by elimination of the gap be tween the gears. Also, the radial load on the supporting orbiting gear bearing is eliminated. A prototype with a reduction ratio of 26 is being tested.
- P. O. Rasmussen, et al, “Development of a High Performance Magnetic Gear,” IEEE Transactions on Industry Applications, Vol. 41, No. 3, 2005, pp. 764-770. http://dx.doi.org/10.1109/TIA.2005.847319
- F. T. Jorgensen, et al, “The Cycloid Permanent Magnetic Gear,” IEEE Transactions on Industry Applications, Vol. 44, No. 6, 2008. pp. 1659-1665. http://dx.doi.org/10.1109/TIA.2008.2006295
- T. B. Martin Jr., “Magnetic Transmission,” US Patent No. 3,378,710, 1968.
- W. J. Mabe Jr., “Magnetic Transmission,” U.S. Patent No. 5,013,949, 1991.
- C. P. Cho and R. A. Bedingfield, “Permanent Magnet Torque/Force Transfer Apparatus,” Patent No. 5,569,111, 1996.
- G. Valmor da Cunha, “Orbital Magnetic Speed Change,” US Patent No. 8,210,980 B2, 2012.
- K. Atallah, “Magnetic Gear,” US Patent No. 7,973,441 B2, 2011.
- L. A. Vazquez-Perez, “Diseno y Construccion de un Redactor de Velocidad Cicloidal Magnetico Balaqnceado,” Master’s Degree Thesis, Universidad Nacional Autonoma de Mexico, 2013.