Microbiological Induced Corrosion on Brass in Recycling Cooling Water System Makeup by Reclaimed Water
- 1 School of Civil Engineering and Architecture, Beijing Jiaotong University, Beijing, China
- 2 School of Civil Engineering and Architecture, Beijing Jiaotong University, Beijing, China
- 3 School of Civil Engineering and Architecture, Beijing Jiaotong University, Beijing, China
- 4 Key Laboratory of Urban Stormwater System and Water Environment, Beijing University of Civil Engineering and Architecture, Ministry of Education, Beijing, China.
- 5 Key Laboratory of Urban Stormwater System and Water Environment, Beijing University of Civil Engineering and Architecture, Ministry of Education, Beijing, China.
Abstract
The impacts of microorganism on brass corrosion were studied in static experiment in this paper. Two main factors, temperature and concentration ratio, were considered. According to the actual operation of recycling cooling water system, four temperatures (15℃, 25℃, 35℃ and 45℃) and four concentration ratios (1, 2.5, 3.5 and 4.5) were selected in the experiment. Corrosion potential, current density, average corrosion rate were measured by time. The results showed that: Microorganism often aggravated corrosion of brass during initial and final stages, but alleviated its corrosion at the middle time. With the extension of time that brass immersed in the solution, the microbes began to intensify the corrosion of the metal. When concentration ratios were 2.5 and 3.5 and temperature was 15℃, microbe promoted brass corrosion obviously and corrosion degrees.
- H.-C. Flemming, “Why Microorganisms Live in Biofilms and the Problem of Biofouling,” In: J. William Costerton, Springer Series on Biofilms, Volume 4 Marine and Indus- trial Biofouling, Springer-Verlag, Berlin Heidelberg, 2009, pp. 3-11.
- W. A. Hamilton, “Sulfate Reducing Bacteria and Anaero- bic Corrosion,” Annual Review of Microbiology, Vol. 39, 1985, pp. 195-217. doi:10.1146/annurev.mi.39.100185.001211
- H. C. Flemming, “Biofouling and Microbiologically In- fluenced Corrosion (MIC)—An Economical and Techni- cal Overview,” In: E. Heitz, W. Sand and H. C. Flemming, Microbial Deterioration of Material, Springer, Heidel- berg, 1996, pp. 5-14.
- M. B. Mcnecil and B. J. Litter, “Mackinawite Formation during Microbial Corrosion,” Corrosion, Vol. 46, No. 7, 1990, pp. 599-601. doi:10.5006/1.3585154
- A. M. EI Din Shams, T. M. H. Saber and A. A. Ham- moud, “Biofilm Formation on Stainless Steels in Arabian Gulf Water,” Desalination, Vol. 107, No. 3, 1996, pp. 251-264. doi:10.1016/S0011-9164(96)00167-1
- E. Heitz and W. Sand, “Microbial Influenced Corrosion of Material,” Springer-Verlag, Berlin, 1996, pp. 82-86. doi:10.1007/978-3-642-80017-7
- H. C. Flemming, “Economical and Technical Overview,” In: Microbially Influenced Corrosion of Materials, Springer- Verlag, Heidelberg, 1996.
- D. Walsh, D. Pope, M. Danford, et al., “The Effect of Microstructure on Microbiologically Influenced Corro- sion,” JOM, Vol. 45, No. 9, 1993, pp. 22-30. doi:10.1007/BF03222429