Modeling and Optimization of Electrical Discharge Machining of SiC Parameters, Using Neural Network and Non-Dominating Sorting Genetic Algorithm (NSGA II)
- 1
Abstract
Silicon Carbide (SiC) machining by traditional methods with regards to its high hardness is not possible. Electro Discharge Machining, among non-traditional machining methods, is used for machining of SiC. The present work is aimed to optimize the surface roughness and material removal rate of electro discharge machining of SiC parameters simultaneously. As the output parameters are conflicting in nature, so there is no single combination of machining parameters, which provides the best machining performance. Artificial neural network (ANN) with back propagation algorithm is used to model the process. A multi-objective optimization method, non-dominating sorting genetic algorithm-II is used to optimize the process. Affects of three important input parameters of process viz., discharge current, pulse on time (T<sub>on</sub>), pulse off time (T<sub>off</sub>) on electric discharge machining of SiC are considered. Experiments have been conducted over a wide range of considered input parameters for training and verification of the model. Testing results demonstrate that the model is suitable for predicting the response parameters. A pareto-optimal set has been predicted in this work.
- S. K. Pal, D. Mandal and P. Saha “modeling of electrical discharge machining process using back propagation neural network and multi-objective optimization using non-dominating sorting genetic algorithm-II “ Journal of Materials Processing Technology, Vol. 186, 2007, pp 154-162.
- G. K. M. Rao, G. Rangajanardhaa, D. H. Rao and M. S. Rao “development of hybrid model and optimization of surface roughness in electric discharge machining using artificial neural networks and genetic algorithm” Journal of Materials Processing Technology, Vol. 209, 2009, pp. 1512-1520.
- K. Wang, H.L. Gelgele, Y. Wang, Q. Yuan and M. Fang “A hybrid intelligent method for modeling the EDM process” Int. J. Machine Tools & Manuf., Vol. 43, 2003, pp. 995-999.
- J.C. Su, J.Y. Kao and Y.S. Tarng “Optimization of the electrical discharge machining process using a GA-based neural network” Int. J. Advance Manufacturing Technology, Vol. 24, 2004, pp. 81-90.
- R. Mahdavinejad, M. Tolouei R.and H. S. Bidgoli “Heat transfer analysis of EDM process on Silicon Carbide” Int. J. numerical methods for heat and fluid flow, Vol. 15, 2005, pp 483-502.
- K. Dev, A. Pratap, S. Agarwal and T. Meyarivan “A fast and elitist multi objective genetic algorithm: NSGA-II” IEEE Trans. E vol. Comput. 6, No. 2., 2002.
- G.K.M. Rao, G.Rangajanardhaa, D.H.Rao and M.S.Rao “Development of hybrid model and optimization of surface roughness in electric discharge machining using artificial neural networks and genetic algorithm” Journal of Materials Processing Technology, Vol. 209, 2009, pp 1512-1520.