Numerical Analysis of the Structure of High-Strength Double-Layer Steel Plate Concrete Shaft by Drilling Method of Water-Bearing Weak Rock Formation
- 1 School of Civil Engineering and Architecture, Anhui University of Science and Technology, Huainan, China
Abstract
In order to ensure the safety of coal mine shaft construction, a double-layer steel plate concrete composite shaft wall structure was proposed. However, fewer studies were conducted on this structure, which made engineers too confused to fully recognize its feasibility of this structure. Hence, based on the previous experimental research on the Taohutu mine construction project in Ordos in Inner Mongolia, this research paper aims to provide a widely deep numerical analysis by the usage of the finite element software, in fact, to establish the corresponding numerical analysis model and make a comparison with the experimental data to get the rationality of the verified model. The influence of the composite characteristics of the steel plate and concrete on the ultimate bearing capacity and stress field of the shaft wall structure is studied here through the method of multi-factor analysis. Also, the optimal design scheme of the double-layer steel plate and concrete composite shaft wall structur e is proposed in this research paper.
- Talebi, S. and Young, R.P. (2021) Microseismic Monitoring in Highly Stressed Granite: Relation between Shaft-Wall Cracking and in Situ Stress. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 29, 25-34. https://doi.org/10.1016/0148-9062(92)91042-4
- Bavi, R., Hajnayeb, A., Sedighi, H.M. and Shishesaz, M. (2022) Simultaneous Resonance and Stability Analysis of Unbalanced Asymmetric Thin-Walled Composite Shafts. International Journal of Mechanical Sciences, 217, 107047. https://doi.org/10.1016/j.ijmecsci.2021.107047
- Wang, Y.S., Zhang, C., Xue, L.B. and Huang, X.G. (2010) Prediction and Safety Analysis of Additional Vertical Stress within a Shaft Wall in an Extra-Thick Alluvium. Mining Science and Technology, 20, 350-356. https://doi.org/10.1016/S1674-5264(09)60207-6
- Zhelnin, M., Kostina, A., Esina, E. and Plekhov, O. (2021) Calculation of the Stress-Strain State in a Shaft Lining during Thawing of the Frozen Wall. Procedia Structural Integrity, 32, 71-78. https://doi.org/10.1016/j.prostr.2021.09.011
- Sungsoo, N., Hyungwon, Y. and Librescu, L. (2006) Effect of Taper Ratio on Vibration and Stability of a Composite Thin-Walled Spinning Shaft. Thin-Walled Structures, 44, 362-371. https://doi.org/10.1016/j.tws.2006.02.007
- Xie, L.D., Gao, X.Y., Yang, Y., Zhi, Y.H. and Dong, Z.X. (2021) Optimization for Connected Steel Plates of Single-Layer Shaft Wall under Blasting Excavation by Numerical Simulation Method. IOP Conference Series: Earth and Environmental Science, 719, Article No. 032013. https://doi.org/10.1088/1755-1315/719/3/032013
- Yao, Z.S., Zhang, P., Cheng, H., Xue, W.P. and Li, X. (2020) Testing of a Dual-Steel-Plate-Confined High-Performance Concrete Composite Shaft Lining Structure and Its Application. Applied Sciences, 10, 2938. https://doi.org/10.3390/app10082938
- Cui, G.X. (1989) The Simulation Tests Principle of Freezing Method Sinking. Journal of China University of Mining and Technology, No. 1, 62-71.
- Yao, Z.S., Xue, W.P., Cheng, H., et al. (2018) Research on the Application of High-Strength Reinforced Concrete Composite Shaft Wall with Inner Steel Plate in Freezing Shaft. Chinese Journal of Mining and Safety Engineering, 35, 663-669.
- Yao, Z.S., Cheng, H. and Rong, C.X. (2008) Experimental Study of High-Strength Reinforced Concrete Composite Shaft Wall of Deep-Frozen Shaft Inner Layer. Chinese Journal of Rock Mechanics and Engineering, No. 1, 153-160.