Research ArticleOpen AccessGoogle Scholar indexed
Modelling and Analysis of Base Isolated Structures with Friction Pendulum System Considering near Fault Events
Department of Civil Engineering, University of Salerno, Salerno, Italy
Department of Civil Engineering, University of Salerno, Salerno, Italy
Department of Civil Engineering, University of Salerno, Salerno, Italy
Department of Civil Engineering, University of Salerno, Salerno, Italy
- 1 Department of Civil Engineering, University of Salerno, Salerno, Italy
- 2 Department of Civil Engineering, University of Salerno, Salerno, Italy
- 3 Department of Civil Engineering, University of Salerno, Salerno, Italy
- 4 Department of Civil Engineering, University of Salerno, Salerno, Italy
Open Journal of Civil Engineering·Volume 03 (2013)·Pages 86–93·Published 30 May 2013·DOI10.4236/ojce.2013.32009
Copy link · social · email
Abstract
The seismic behavior of base isolated structures with friction pendulum slide bearings devices subjected to near fault events characterized by significant vertical ground motion components is investigated. In particular, in order to evaluate the effects of vertical components on seismic response, non-linear dynamic analysis, carried out by using several numerical models, have been performed by considering two near-fault seismic events, L’Aquila 2009 and Emilia Romagna 2012. The obtained results show that increasing vertical seismic motion base shear significantly increases while relative displacements increase very little.
KeywordsBase Isolated StructuresFriction Pendulum Slide BearingsSpatial Seismic Demand
- A. S. Mokha, M. C. Constantinou and A. M. Reinhorn, “Verification of Friction Model of Teflon Bearings under Triaxial Load,” Journal of Structural Engineering, Vol. 119, No. 1, 1993, pp. 240-261.
- G. Mosqueda, A. S. Whittaker and G. L. Fenves, “Characterization and Modeling of Friction Pendulum Bearings Subjected to Multiple Components of Excitation,” Journal of Structural Engineering, Vol. 130, No. 3, 2004, pp. 433-442. doi:10.1061/(ASCE)0733-9445(2004)130:3(433)
- F. Khoshnoudian and V. Rezai Hagdoust, “Response of Pure-Friction Sliding Structures to Three Components of Earthquake Excitation Considering Variations in the Co efficient of Friction,” Civil Engineering, Vol. 16, No. 6, 2009, pp. 429-442,
- CSI Analysis Reference Manual, “SAP 2000,” Berkeley.
- MATLAB, “The Language of Technical Computing,” The Mathworks.
- L. Petti and A. Lodato, “Preliminary Spatial Analysis and Comparison between Response Spectra Evaluated for Emilia Romagna Earthquakes and Elastic Demand Spectra According to the New Seismic Italian Code,” Report ReLuis, 2012.
- L. Petti and I. Marino, “Preliminary Comparison between Response Spectra Evaluated at Close Source for L’aquila Earthquake and Elastic Demand Spectra According to the New Seismic Italian Code,” Report ReLuis, 2009.
- O. Soon-Taek and S. K. Young, “Experimental and Analytical Investigation of a Seismically Isolated Bridge Model with Friction Pendulum System,” KSCE Journal of Civil Engineering, Vol. 2, No. 3, 1998, pp. 265-272.
- Nistir 5800, “Guidelines for Pre-qualification, Prototype and Quality Control Testing of Seismic Isolation System,” 1996, 143 p.
- V. A. Nadein, Yu. N. Drozdov, V. N. Puchkov and M. V. Puchkov, “Characteristics of Pendulum Sliding Bearings Used as Seismic Isolators,” Russian Engineering Research, Vol. 27, No. 2, 2007, pp. 85-92.
- Y. K. Wen, “Method for Random Vibration of Hysteretic Systems,” Journal of the Engineering Mechanics Division, Vol. 102, No. 2, 1976, pp. 249-263.
- Y. J. Park, Y. K. Wen and A. H.-S. Ang, “Random Vibration of Hysteretic Systems under Bi-Directional Ground Motions,” Earthquake Engineering and Structural Dynamics, Vol. 14, No. 4, 1986, pp. 543-557.
- S. Nagarajaiah, A. M. Reinhorn and M. C. Constantinou, “3D-Basis: Non-Linear Dynamic Analysis of Three-Dimensional Base Isolated Structures: Part II,” Technical Report NCEER-91-0005, National Center for Earthquake Engineering Research, State University of New York at Buffalo, Buffalo, 1991.