Experimental Behavior of Partially Prestressed High Strength Concrete Beams
- 1 Department of Structural Engineering, Faculty of Engineering, Ain Shams University, Cairo, Egypt
- 2 Department of Structural Engineering, Faculty of Engineering, Ain Shams University, Cairo, Egypt
- 3 Department of Structural Engineering, Faculty of Engineering, Ain Shams University, Cairo, Egypt
- 4 Department of Structural Engineering, Faculty of Engineering, Ain Shams University, Cairo, Egypt
Abstract
In the last few decades, prestressed concrete has been rapidly used in bridge engineering due to the enormous develop ment in the construction techniques and the increasing need for long span bridges. High strength concrete has been also more widely spread than the past. It currently becomes more desirable as it has better mechanical properties and dura bility performance. Major defect of fully prestressed concrete is its low ductility; it may produce less alarming signs than ordinary reinforced concrete via smaller deflection and limited cracking. Therefore, partially prestressing is consi dered an intermediate design between the two extremes. So, combining high strength concrete with partial prestressing will result in a considerable development in the use of prestressed concrete structures regarding the economical and durability view points. This study presents the results of seven partially prestressed high strength concrete beams in flexure. The tested beams are used to investigate the influence of concrete compressive strength, prestressing steel ratio and flange width on the behavior of partially prestressed beams. The experimentally observed behaviors of all beams were presented in terms of the cracking load, ultimate load, deflection, cracking behavior and failure modes.
- M. Collins and D. Mitchell, “Prestressed Concrete Structures,” Prentice Hall, Englewood Cliffs (NJ, USA), 1991.
- ACI Committee, 363, “State-of-the-Art Report on High Strength Concrete,” (1992 (Reaproved 1997)), pp. 1-37.
- A. A. Abdelrahman, “Serviceability of Concrete Beams Prestressed by Fiber Reinforced Plastic Tendons,” Ph.D. Thesis, University of Manitoba, Manitoba, 1995.
- Y. Zandi, Y. Akgün and A. Durmus, “Investigating the Use of High Performance Concrete in Partially Prestressed Beams and Optimization of Partially Prestressed Ratio,” Indian Journal of Science and Technology, 2012, pp. 2991-2996.
- H. Manalip, M. Pinglot and M. Lorrain, “Behavior of the Compressed Zone of Reinforced and Prestressed High Strength Concrete Beams,” ACI Journal, Vol. 149, 1994, pp. 209-226 (SP149-12).
- S. W. Shin, K. Ghosh and J. Moreno, “Flexural Ductility of Ultra-High-Strength Concrete Members,” ACI Structural Journal, Vol. 86, No. 4, July/Aug., 1989, 39 p.