Comparative Study of the Types of Photovoltaic Panels Used in Solar Pumping Systems in Dry Tropical Zones: Case of Adamawa Region in Cameroon
- 1 Department of Electrical Engineering, University Institute of Ngaoundéré, Ngaoundéré, Cameroon
- 2 Department of Electrical Energy and Automation, National School of Agro-Industrial Sciences, Ngaoundéré, Cameroon
- 3 Department of Electrical Energy and Automation, National School of Agro-Industrial Sciences, Ngaoundéré, Cameroon
- 4 Department of Physics, University of Ngaoundéré, Ngaoundéré, Cameroon
Abstract
In the dry tropical zone where access to water is increasingly difficult for populations, solar pumping units are increasingly installed to provide water to population. In the local market, there are essentially two types of solar panels, namely monocrystalline and polycrystalline. However, the part of the local market is more dominated by the polycrystalline panel. In this work, comparative studies are carried out in order to characterize the two types of solar panels with regard to local constraints. Tests were carried out over the course of the sun to establish the performance of each type. The panels used have the same electrical characteristics and are connected to loads with same characteristics. Under the set operating conditions, the monocrystalline panel presents more performance than the polycrystalline panel. Although the local market is dominated by the polycrystalline panel, dust deposition tests on the surface of the panels show that the performance of the polycrystalline panel is more affected compared to the performance of the monocrystalline panel.
- Ndiaye, A. (2013) Étude de la dégradation et de la fiabilité des modules photovoltaïques-Impact de la poussière sur les caractéristiques électriques de performance. Ecole Supérieure Polytechnique (ESP).
- Avila, N., Carvallo, J.P., Shaw, B. and Kammen, D.M. (2017) The Energy Challenge in Sub-Saharan Africa: A Guide for Advocatses and Policy Makers. In: Pfeifer, K., Ed., Generating Energy for Sustainable and Equitable Development , Oxfam Research Backgrounder Series, 1-79.
- Boussaibo, A., Kamta, M., Badohok, S. and Kayem, J. (2017) Performance of a Brackish Water Desalination Unit Coupled to a Photovoltaic Source without Energy Storage. International Journal of Advanced Engineering Research and Applications , 2, 616-627.
- Hottel, H.C. and Woertz, B.B. (1942) The Performance of Flat-Plate Solar-Heat Collectors. Journal of Fluids Engineering , 64, 91-103. https://doi.org/10.1115/1.4018980
- Kazet, M., Mouangue, R., Kuitche, A., Ndjaka, J.M. and Takam, S. (2023) Modélisation et simulation numérique des données du vent en vue d’une prédiction de l’énergie électrique d’origine éolienne: Cas d’un site de la ville de Ngaoundéré au Cameroun. Journal of Renewable Energies , 16, 527-538. https://doi.org/10.54966/jreen.v16i3.397
- Ngoussandou, B., Nisso, N., Kidmo, D.K., Sreelatha, E., Jember, Y.B., Das, S., et al . (2023) Optimal Energy Scheduling Method for the North Cameroonian Interconnected Grid in Response to Load Shedding. Sustainable Energy Research , 10, Article No. 14. https://doi.org/10.1186/s40807-023-00084-x
- Kitmo, Tchaya, G.B. and Djongyang, N. (2022) Optimization of Hybrid Grid-Tie Wind Solar Power System for Large-Scale Energy Supply in Cameroon. International Journal of Energy and Environmental Engineering , 14, 777-789. https://doi.org/10.1007/s40095-022-00548-8
- Yaouba,, Bajaj, M., Welba, C., Bernard, K., Kitmo,, Kamel, S., et al . (2022) An Experimental and Case Study on the Evaluation of the Partial Shading Impact on PV Module Performance Operating under the Sudano-Sahelian Climate of Cameroon. Frontiers in Energy Research , 10, Article 924285. https://doi.org/10.3389/fenrg.2022.924285
- Bello-Pierre, N., Nisso, N., Kaoga, D.K., Kitmo. and Tchakounté, H. (2023) Energy Efficiency in Periods of Load Shedding and Detrimental Effects of Energy Dependence in the City of Maroua, Cameroon. Smart Grid and Renewable Energy , 14, 61-71. https://doi.org/10.4236/sgre.2023.144004
- Amou, K., Sagna, K., Lare, T.Y. and Napo, K. (2016) Modélisation et simulation d’un générateur photovoltaïque: Cas du module polycristallin Ecoline LX-260P installé au dispensaire de Sévagan (Togo). Revue des Energies Renouvelables , 19, 633-645.