Field Comparison of Two Sampling Methods for Triglycidyl Isocyanurate
- 1 Brigham Young University, Provo, USA
- 2 Brigham Young University, Provo, USA
- 3 Brigham Young University, Provo, USA
Abstract
Side-by-side field sampling comparisons for Triglycidylisocyanurate (TGIC) w ere conducted using 1) a laboratory method to determine specific levels of airborne TGIC, and 2) the NIOSH 0500 method for Particulates Not Otherwise Regulated for total aerosol mass. Resulting concentrations from the NIOSH 0500 method in conjunction with the powder coating manufacturer safety data sheet are then used to estimate TGIC levels in air. This second method is designed as a simpler and less expensive sampling and analytical method. Results show that the NIOSH 0500 method resulted in airborne concentrations up to ten times greater than the laboratory method result ing in specific for TGIC. Coefficients of variation show that the laboratory method had the least variability. We conclude that the NIOSH 0500 method and subsequent calculation should not be used to quantify TGIC levels in powder coatings. However, this method may be used to monitor effectiveness of exposure control.
- C. G. T. Mathias, “Allergic Contact-Dermatitis from Triglycidylisocyanurate in Polyester Paint Pigments,” Con- tact Dermatitis, Vol. 19, No. 1, 1998, pp. 67-68. http://dx.doi.org/10.1111/j.1600-0536.1988.tb02877.x
- L. Meuleman, A. Goossens, C. Linders, F. Rochette and B. Nemery, “Sensitization to Triglycidylisocyanurate (TGIC) with Cutaneous and Respiratory Manifestations,” Allergy, Vol. 54, No. 7, 1999, pp. 752-756. http://dx.doi.org/10.1111/j.1398-9995.1999.00103.x
- R. Jolanki, L. Kanerva, T. Estlander and K. Tarvainen, “Concomitant Sensitization to Triglycidylisocyanurate, Diaminodiphenylmethane and 2-Hydroxyethyl Methacrylate from Silk-Screen Printing Coatings in the Manufacture of Circuit Boards,” Contact Dermatitis, Vol. 30, No. 1, 1994, pp. 12-15. http://dx.doi.org/10.1111/j.1600-0536.1994.tb00721.x
- S. Quirce, M. Fernandez-Nieto, M. de Gorgolas, G. Renedo, J. Carnes and J. Sastre, “Hypersensitivity Pneumonitis Caused by Triglycidylisocyanurate,” Allergy, Vol. 59, No. 10, 2004, pp. 1128-1128. http://dx.doi.org/10.1111/j.1398-9995.2004.00506.x
- P. Piirila, T. Estlander, H. Keskinen, R. Jolanki, A. Laakkonen, P. Pfaffli, et al., “Occupational Asthma Caused by Triglycidylisocyanurate (TGIC),” Clinical & Experimental Allergy, Vol. 27, No. 5, 1997, pp. 510-514. http://dx.doi.org/10.1111/j.1365-2222.1997.tb00738.x
- S. Allmaras, “Worker Exposure to 1,3,5-Triglycigyl Isocyanurate (TGIC) in Powder Paint Coating Operations,” Applied Occupational and Environmental Hygiene, Vol. 18, No. 3, 2003, pp. 151-153. http://dx.doi.org/10.1080/10473220301354
- C. Geigy, “Analytical Method AV-052.1—Araldite PT 810 Pure and in Powder Coatings,” Basel, Switzerland, 1991.
- HSE, “Methods for the Determination of Hazardous Substances—Triglycidyl Isocyanurate (and Coating Powders Containing Isocyanurate) in Air,” MDHS 85, Sudbury, 1997.
- HSE, “Control of Exposure to Triglycidyl Isocyanurate (TGIC) in Coating Powders,” EIS No. 15 (rev. 2), Sudbury, 2003.
- National Institute for Occupational Safety and Health (NIOSH), “NIOSH Manual of Analytical Methods, 4th ed.,” DHHS Publication 94-113, Cincinnati, OH, NIOSH, 1994.
- J. White, “Determination of Triglycidyl Isocyanurate from Powder Coatings in Occupational Hygiene Samples by Gas Chromatography with Mass Spectrometric Detection,” The Annals of Occupational Hygiene, Vol. 48, No. 6, 2004, pp. 555-563. http://dx.doi.org/10.1093/annhyg/meh046