Modeling and Simulation of a Renewable Energy Based-Medical Herb Dryer
- 1 PV Cells Department, Electronics Research Institute, Cairo, Egypt.
- 2 PV Cells Department, Electronics Research Institute, Cairo, Egypt.
- 3 PV Cells Department, Electronics Research Institute, Cairo, Egypt.
Abstract
The medical herbs should be dried directly after harvesting, otherwise, insects and fungi spoilage them. Conventional drying methods such as open sun drying and conventional fuel dryers are not suitable, since they contaminate the herbs, decrease the drying efficiency and at the same time increase the drying cost. Therefore, the recent trend is toward the harnessing the renewable energy to dry the medical herbs. This paper presents a new controlled drying system, which uses a solar collector and an electric heater to heat the drying air, and a PV-WIND hybrid system to supply the required electric energy to the dryer electric load. This paper also presents the dynamic modeling, simulation, and control of the suggested thermal system ( i.e ., the solar thermal system and the electrical heater). Moreover, this paper, exhibits the different results of the thermal system, to check the effectiveness of this system that fulfills the requirements of the drying operation. The system results are found to satisfy the ultimate goals of the drying operation.
- G. Grang and H. P. Kumar, “Developments in Solar Drying,” Proceedings of the Second Asian-Oceania Drying Conference (ADC 2001), Pulau Pinang, 2001, pp. 297 319.
- J. Howell, R. Bannerot and G. Vliet, “Solar-Thermal Energy Systems: Analysis and Design,” McGraw-Hill, Inc., New York, 1982.
- A. Vieira da Rosa, “Fundamentals of Renewable Energy Processes,” 3rd Edition, Academic Press, Waltham, 2013.
- J. W. Twidel and A. D. Weir, “Renewable Energy Resources,” Cambridge, London, 1986. doi:10.4324/9780203478721
- X. Xu, M. M. Meyers, B. G. Sammakiak and B. T. Murray, “Thermal Modeling and Life Prediction of Water-Cooled Hybrid Concentrating Photovoltaic/Thermal Collectors,” Journal of Solar Energy Engineering, Transactions of the ASME, Vol. 135, No. 1, 2013.
- T. A. Stuetzle, “Automatic Control of the 30 MWe SEG VI Parabolic Trough Plant,” M.Sc. Thesis, Wisconsin Madison University, Madison, 2002.
- T. A. Stuetzle, “Automatic Control of the 30 MWe SEG VI Parabolic Trough Plant,” M.Sc. Thesis, Wisconsin Madison University, Madison, 2002.
- P. M. Doran, “Bioprocess Engineering Principles,” 2nd Edition, Academic Press, Waltham, 2013.
- N. Elshahat and A. Zeit, “Aromatic Plants & Its Agricultural-Medical Products,” Arabic, Inc., Egypt, 2003.