PV-Grid Tie System Energizing Water Pump
- 1 Electrical Engineering Department, Palestine Polytechnic University (PPU), Hebron, Palestine.
- 2 Electrical Engineering Department, Palestine Polytechnic University (PPU), Hebron, Palestine
Abstract
This paper presents the behaviours of three-phase induction motor driving centrifugal pump under various solar irradiation levels, where the motor speed and torque depend on the source voltage and frequency, while the water-flow rate depends on the motor speed, density, and static head according to affinity flow. Matlab/Simulink model is proposed for studying the behaviours of these machines with respect to water flow capacity, motor current, electro-magnetic torque, and motor efficiency. The proposed photovoltaic with maximum power point tracking model based on observation and perturbation (O&P) maximum power tracking model is applied. The output voltage is regulated throughout Buck-Boost converter with purpose maintaining the output voltage at predetermined values. Since Induction motors are widely used in pump systems, the electromagnetic torque, water-flow rate are studied for various source frequencies. Comparison analysis is conducted for both motors with respect to water flow-rate, heads elevation, and motor current. In addition to that, the proposed system presents Photovoltaic-Grid (PV-Grid) Integrated model, where the power shortage required for normally operation of the pump is drawn from the electrical grid.
- Q. Meng and W. Hu, “Roof Cooling Effect with Humid Porous Medium,” Energy and Buildings, Vol. 37, No. 1, 2005, pp. 1-9. doi:10.1016/j.enbuild.2003.11.004
- P. C. Agrawal, “A Review of Passive Systems for Natural Heating and Cooling of Buildings,” Solar and Wind Technology, Vol. 6, No. 5, 1989, pp. 557-567. doi:10.1016/0741-983X(89)90091-X
- M. Chikh, A. Mahrane and A. Chikouche, “A Proposal for Simulation and Performance Evaluation of StandAlone PV Systems,” Proceedings of the 23rd EPVSEC, Valence, Spain, 2008, pp. 3579-3584.
- E. Worrell, S. Ramesohl and G. Boyd, “Advances in EnErgy Forecasting Models Based on Engineering Economics,” Annual Review of Environmental Resources, Vol. 29, 2004, pp. 345-381. doi:10.1146/annurev.energy.29.062403.102042
- S. B. Kjaer, J. K. Pedersen and F. Blaabjerg, “A Review of Single-Phase Grid-Connected Inverters for Photovoltaic Modules,” IEEE Transactions on Industry Applications, Vol. 41, No. 5, 2005, pp. 1292-1306. doi:10.1109/TIA.2005.853371
- I. Odeh, Y. G. Yohanis and B. Norton, “Economic ViabilIty of Photovoltaic Water Pumping Systems,” Journal of Solar Energy, Vol. 80, No. 7, 2006, pp. 850-860. doi:10.1016/j.solener.2005.05.008
- I. I. Lonel, “Pumps and Pumping,” Elsevier Publications, Amsterdam, 1986.
- E. V. Meidanis, G. A. Vokas and J. K. Kaldellis, “Theoretical Simulation and Experimental Analysis of a PVBased Water Pumping System,” Lab of Soft Energy Applications & Environmental Protection, TEI of Piraeus. powerelectronics.teipir.gr/Papers/MEDPOWER08_170.pdf
- J. Appelbaum and J. Bany, “Performance Analysis of DC Motor Photovoltaic Converter System,” Solar Energy, Vol. 22, No. 5, 1979, pp. 439-445. doi:10.1016/0038-092X(79)90173-7
- M. Abu-Aligh, “Design of Photovoltaic Water Pumping System and Compare It with Diesel Powered Pump,” JJMIE, Vol. 5, No. 3, 2011, pp. 273-280.
- The Mathworks, Inc., “Matlab and Simulink,” Version R2010a. http://www.mathworks.com
- S. B. Kjaer, J. K. Pedersen and F. Blaabjerg, “A Review of Single-Phase Grid-Connected Inverters for Photovoltaic Modules,” IEEE Transactions on Industry Applications, Vol. 41, No. 5, 2005, pp. 1292-1306. doi:10.1109/TIA.2005.853371
- S. J. Chapman, “Electric Machinery Fundamentals,” McGraw-Hill, New York, 2003.
- G. McPherson and R. D. Laramore, “An Introduction to Electric Machines and Transformers,” Wiley, New York, 1990.