Research ArticleOpen AccessGoogle Scholar indexed
Sizing of Converters Interfacing the Rotor of Wind Driven DFIG to the Power Grid
- 1
- 2
Smart Grid and Renewable Energy·Volume 02 (2011)·Pages 300–304·Published 2 August 2011·DOI10.4236/sgre.2011.23034
Copy link · social · email
Abstract
In this paper, the operation of the Double Fed Induction Generator (DFIG) in the range from synchronous speed down to sub-synchronous speeds is analyzed using the power-flow approach. The objective of this analysis is to determine a ceiling for the rating of the converter interfacing the rotor of the wind driven double fed induction generator (DFIG) to the grid. Sizing the converter is an important issue in determining the economic viability of using the DFIM as a generator at synchronous and sub-synchronous speeds in wind energy conversion systems. The size of the converter is proved to be less than 10% of the rated power of the DFIG, which is 40% to 67% lower than that estimated in previous publications.
KeywordsDouble Fed Induction GeneratorConverter SizingCost LoweringWind Energy Conversion System
- J. Hu and Y. He, “Reinforced Control and Operation of DFIG-Based Wind Power Generation System under Unbalanced Grid Voltage Conditions,” IEEE Transactions on Energy Conversion, Vol. 24, No. 4, December 2009, pp. 905-915. doi:10.1109/TEC.2008.2001434
- D. Saidani, O. Hasnaoui and R. Dhifaoui, “Control of Double Fed Induction Generator for Wind Conversion System,” International Journal of Sciences and Techniques of Automatic Control & Computer Engineering, Vol. 2, No. 2, December 2008, pp. 710-721.
- M. A. Saleh and M. N. Eskander, “Sub-Synchronous Range of Operation for a Wind Driven Double-Fed Induction Generator,” Journal of Power Electronics, Vol. 10, No. 1, January 2010.