Comparison the Performances of Three Earthing Systems for Micro-Grid Protection during the Grid Connected Mode
- 1
- 2
- 3
Abstract
This paper presents, tests and compares three earthing systems (TT, TN and IT) for Micro-Grid (MG) protection against various fault types during the connected mode. The main contribution of this work is including the models of all the micro sources which interfaced to the MG by power electronic inverters. Inverters in turns are provided with current limiters and this also included in the inverter models to exactly simulate the real situation in the MG during fault times. Results proved that the most suitable earthing system for MG protection during the connecting mode is the TN earthing system. That system leads to a suitable amount of fault current sufficient to activate over current protection relays. With using TN system, Touch voltages at the faulted bus and all other consumer’s buses are less than the safety limited value if current limiter is included with the transformer of the main grid which connects MG. For the two others earthing systems (TT and IT), fault current is small and nearly equal to the over load current which make over current protection relay can not differentiate between fault current and overload current. All models of micro sources, earthing systems, inverters, main grid and control schemes are built using Matlab<sup>®</sup>/Simulink<sup>®</sup> environment.
- R. M. Kamel and B. Kermanshahi, “Design and Implementation of Models for Analyzing the Dynamic Performance of Distributed Generators in the Micro Grid Part I: Micro Turbine and Solid Oxide Fuel Cell,” Scientia Iranica, Transactions D, Computer Science & Engi- neering and Electrical Engineering, Vol. 17, No. 1, June 2010, pp. 47-58.
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “Micro-Grid Dynamic Response Enhancement Using New Proportional Integral Wind Turbine Pitch controller and Neuro-Fuzzy Photovoltaic Maximum Power Point Track- ing Controller,” Electric Power Components and Systems, Vol. 38, No. 2, Januaruy 2010, pp. 212-239.
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “Wind Power Smoothing Using Fuzzy Logic Pitch Controller and Energy Capacitor System for Improvement Micro-Grid Performance in Islanding Mode,” Energy, Vol. 35, No. 4, March 2010, pp. 2119-2129. doi:org/10.1016/j.energy.2010.01.030
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “Micro Grid Transient Dynamic Response Enhancement during snd Subsequent to Huge and Multiple Disturbances by Connecting It with Nearby Micro Grids,” International Journal of Sustainable Energy, Vol. 30, No. 4, August 2010, pp. 223-245. doi:org/10.1080/1478646X.2010.509499
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “Effect of Micro Sources Failure on Dynamic Performance of the Micro-Grid during and Subsequent to Islanding Process,” ISESCO Science and Technology Vision, Vol. 6, No. 9, May 2010, pp. 2-10.
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “Improvement of Transient Dynamic Response of Micro-Grid Subsequent Islanding and Failure of Micro Sources by Connected Two Nearby Micro-Grids,” ISESCO Science and Technology Vision, Vol. 5, No. 8, November 2009, pp.46-55.
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “A Novel PI Pitch Controller and Energy Capacitor System for Reducing Wind Power Fluctuations and Keeping Micro-Grid Stable Subsequent Islanding Occurrence,” International Journal of Power & Energy Systems, Vol. 30, No. 2, April 2010, pp. 131-138.
- R. M. Kamel and B. Kermanshahi, “Optimal Size and Location of Distributed Generations for Minimizing Power Losses in a Primary Distribution Network,” Scientia Iranica, Transactions D, Computer Science & Engineering and Electrical Engineering, Vol. 16, No. 6, December 2009, pp. 137-144.
- R. M. Kamel, A. Chaouachi and K. Nagasaka, “Carbon Emissions Reduction and Power Losses Saving besides Voltage Profiles Improvement Using Micro Grids,” Low Carbon Economy, Vol. 1, No. 1, October 2010, pp. 1-7. doi:org/10.4236/lce.2010.11001